Appendices
In - Identification
Introduction
Parameters
The modem reports the result corresponding to the entered command parameter to the DTE.
I4
I5
I6
Code
I0
I1
I3
The parameters are:
Description
Gives the product code (e.g. '14400').
Gives the pre-calculated checksum of the read-only memory ROM (e.g. '007').
Gives the firmware revision level (e.g. 'V1.000S').
Gives the identification string defined by the OEM (e.g. 'RC96ACL').
Gives the country code (e.g. '022').
Gives the model of the modem data pumping device.
Result codes The following table lists the possible command responses.
Code
OK
ERROR
Description n = 0 to 6.
If n is not in the range 0 to 6.
146
35013154.02 07/2008
