Appendices
Mn - Loudspeaker command
Introduction
Parameters
This command controls the moment at which the loudspeaker is active or deactivated. The parameter value, if valid, is written in bits 2 and 3 of S22.
The parameters are:
Code
M0
M1
M2
M3
Description
The loudspeaker is always deactivated.
The loudspeaker is activated during establishment of the call but deactivated during reception of the carrier (default value).
The loudspeaker is always activated.
The loudspeaker is deactivated during reception of the carrier and during dialing.
Result codes The following table lists the possible command responses.
Code
OK
ERROR
Description n = 0 to 3.
If n is not in the range 0 to 3.
148
35013154.02 07/2008
