Controller Device Editor
Services
Services Tab
The Services tab is divided in three parts:
RTC Configuration
Device Identification
Post Configuration
The figure below shows the Services tab:
78
NOTE: To have controller information, you must be connected to the controller.
EIO0000004135 09/2020
Controller Device Editor
Element
RTC
Configuration
PLC Time
Read
Local Time
Write
Synchronize with local date/time
Device Identification
Post Configuration
Description
Displays the date and time read from the controller when the Read button is clicked, with no conversion applied. This read-only field is initially empty. If Write as UTC is selected, PLC Time is in UTC.
Reads the date and time saved on the controller and displays the values in the PLC Time field.
Lets you define a date and a time that are sent to the controller when the Write button is clicked. If necessary, modify the default values before clicking the Write button. A message box informs you about the result of the command. The date and time fields are initially filled with the current PC settings.
Writes the date and time defined in the Local time field to the logic controller. A message box informs you of the result of the command. Select the Write as UTC checkbox before running this command to write the values in UTC format.
Lets you directly send the PC settings. A message box informs you of the result of the command. Select Write as UTC before running this command to use UTC format.
Displays the Firmware Version, the Boot Version, and the
Coprocessor Version of the selected controller, if connected.
Displays the application parameters overwritten by the Post configuration
( see page 235 ) .
EIO0000004135 09/2020
79
