Product Overview. Linksys AC1900/AC1750 WiFi Range Extender, Q87-RE6800, Q87-RE7000

Product Overview

Front view

The indicator LED on the front of the range extender gives you information about power, updating and signal strength.

Power Light Status/ description

Blinking Green • Starting up.

• Resetting to factory defaults.

• Upgrading firmware.

Solid Green

Solid Amber

Blinking Amber

• Ready to use.

• Weak connection with the router.

Fix: Unplug the extender, and move it closer to the router.

• Not connected to the router or other error.

Fix:

1.

Make sure your router has an Internet connection and Wi-Fi is turned on.

2.

If the router is in order, unplug the extender, move it closer to the router, plug it back in, wait one minute, reconnect to your network.

3

Side view

WPS™ Button —Use Wi-Fi Protected Setup to automatically and securely add compatible wireless

devices to your network with Push Button Connect. Refer to Using WPS on page 6 .

Reset Button —Press and hold until the power light on the front of the range extender blinks to reset to factory defaults. You can also restore the defaults from the Administration > Factory

Defaults screen in the extender’s settings interface (page 14 ).

Bottom view

LED —The LED confirms an Ethernet connection to the main router.

4

Ethernet Port (blue) —Connect wired devices to your wireless network with Ethernet (network) cables. The green light turns on when an Ethernet device is connected and active on this port. The light blinks when the extender is sending or receiving data over the Ethernet port.

5