advertisement
To enjoy surround sound
Do the connections, settings, and adjustments in the order shown to enjoy surround sound.
Be sure to make the correct speaker settings. If, for example, you have not connected a center speaker and you leave the initial setting value of LARGE as it is, then dialog and other sounds may not be reproduced.
Connect the equipment
( a
Pages 10–13.)
Front speaker
(left)
(not included)
Center speaker
(not included)
30
°
30
°
Front speaker
(right)
(not included)
Subwoofer
(not included)
30
°
30
°
120
°
120
°
Surround speaker
(left)
(not included)
Surround speaker
(right)
(not included)
Position and connect the speakers
( a
Pages 14–16.)
The front, center, and surround speakers should be placed at approximately the same distance from the listening position. The angles in the diagram are approximate.
Set the presence and type
(small/large), distance and filter of the speakers you have connected
( a
Pages 17–18.)
Adjust the level for the speakers
( a
Page 19.)
In SIZE
Select LARGE or SMALL for the front speakers
Select LARGE, SMALL, or NONE for the center and surround speakers
Select YES or NO for the subwoofer
In DISTANCE
Enter the distance of the front, center, and surround speakers from the listening position
In FILTER
Enter the cutoff frequency for your subwoofer based on the bass capability of your front speakers
While sitting in the usual listening position, use the test signal to adjust the volume of the speakers to the same apparent level.
When using DVD 6CH INPUT mode
These settings need to be changed on the player.
Read the player’s instructions for setting details.
Sit back and enjoy the experience
( a
Pages 22–23.)
5
RQT5518
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 1 Front Page
- 2 Table of contents
- 3 Caution for AC Mains Lead
- 4 Safety precautions
- 5 To enjoy surround sound
- 6 Front panel controls
- 8 Remote control
- 9 Concerning the remote control
- 10 Connections
- 10 Connecting a DVD player
- 11 Connecting video equipment
- 12 Connecting audio equipment
- 12 Antenna connections
- 13 Connecting the AC mains lead and other information
- 14 Speaker connections
- 14 Placement of speakers
- 14 Connecting speakers
- 17 Preparatory steps
- 17 Speaker settings
- 19 Adjusting speaker output level
- 20 DSP sound modes
- 22 Enjoying the sounds
- 24 To enjoy bi-amp sound
- 25 To adjust the tone quality
- 25 To adjust the sound balance
- 25 When using the VCR 3 terminals
- 26 Switching DVD analogue input
- 27 VGCA mode
- 28 The radio
- 28 Sequential tuning
- 29 Direct tuning
- 30 Preset tuning
- 32 RDS broadcasts Only for the United Kingdom
- 36 Other functions
- 36 To listen through headphones
- 36 Dynamic range compression
- 37 To mute the sound level
- 37 When using the unit in a darkened room
- 38 The remote control
- 39 To operate the receiver
- 41 To operate a CD player or MD deck
- 41 To operate a cassette deck
- 43 To watch TV broadcasts
- 43 To watch video tapes
- 45 To operate a DVD player
- 46 To change the remote control code
- 48 Making a recording
- 48 Recording on a tape deck or VCR
- 49 Timer function
- 49 Setting the timers
- 50 Troubleshooting guide
- 51 The RESET function
- 51 Maintenance
- 52 Specifications