advertisement
IP POWER 9258 USER MANUAL
4. Hardware & Software installation
Before you star to use IP Power 9258, please follow the steps below
Check the package to make sure the contents is complete.
Prepare one Ethernet HUB or Router
Check the voltage of the power supply to make sure it is AC 110-240 volt
Please confirm the specification of your power cable.
IP Power 9258S: for 220-250V, please use the 10A power cable.
IP Power 9258T: for 100-120V, please use the 15A power cable.
Hardware installation
a) Connect the 9258 to HUB through network wire. b) Connect the HUB or Router to the internet (either through DSL or Cable modem). c) Connect the power adapter to the 9258. d) Connect the power adapters of under control electric equipment to corresponding out port of 9258.
1. Turn on your computer and the power adapter of IP Power 9258
*
For 220-250V, please use power wire can support 10A current.
Max. Output current: (total) 10A, (individual) 6A.
Max. Output current: (total) 15A, (individual) 6A
- 6 -
advertisement
Related manuals
advertisement
Table of contents
- 4 1. INTRODUCTION
- 5 SPECIFICATION
- 6 3. INTERFACE DESCRIPTION
- 7 HARDWARE & SOFTWARE INSTALLATION
- 8 5. INITIAL SETTINGS
- 11 6. HARDWARE CONTROL & SETTINGS
- 12 7. CONTROL & SETTINGS
- 26 8. SNMP – MIB TREE
- 27 9. HTTP COMMAND & TELNET
- 27 a.) Set Power Command
- 27 b.) Read Power Command
- 28 c.) Power Delay
- 28 d.) Read Schedule
- 29 e.) Setup Schedule
- 29 Read current value
- 30 TELNET
- 31 10. FAQ