advertisement
IP POWER 9258 USER MANUAL
TELNET
The 9258 supports telnet protocol and can be controlled in a telnet enabled environment.
To Login to the 9258 in telnet
1.) Make sure to go to command prompt and type in Telnet and the IP Address of your 9258 device.
2.) Then type in the login and password in the following format. admin:12345678
Telnet Commands
Help: The help command will provide all the commands available on the 9258.
To get the commands in help type: help in the telnet protocol.
Set power: The set power command allows the device to turn on and turn off ports on the device. To set power on the device type
Telnet Command
setpower p6=1111 setpower p6=0000
Port 1
On
Off
Port 2 Port 3
On On
Off Off
Port 4
On
Off setpower p6=0101 setpower p6=1010
Off
On
On
Off
Off
On
On
Off
Get power: The get power command gives you the current status of the device. To get power on the device type:
- 29 - VER. 5.01
advertisement
Related manuals
advertisement
Table of contents
- 4 1. INTRODUCTION
- 5 SPECIFICATION
- 6 3. INTERFACE DESCRIPTION
- 7 HARDWARE & SOFTWARE INSTALLATION
- 8 5. INITIAL SETTINGS
- 11 6. HARDWARE CONTROL & SETTINGS
- 12 7. CONTROL & SETTINGS
- 26 8. SNMP – MIB TREE
- 27 9. HTTP COMMAND & TELNET
- 27 a.) Set Power Command
- 27 b.) Read Power Command
- 28 c.) Power Delay
- 28 d.) Read Schedule
- 29 e.) Setup Schedule
- 29 Read current value
- 30 TELNET
- 31 10. FAQ