advertisement
IP POWER 9258 USER MANUAL
9. HTTP Command & TELNET
CGI / HTTP Commands
Http commands allow you to control the device with commands. The basic commands are provided below.
There are two ways to input http commands with authorization required
* Password in http: for Browser IE 7.0 or below
http://login:password@ipaddrss:port/set.cmd?cmd=command
* Password not in http: for Browser IE 7.0 and higher http://ipaddrss:port/set.cmd?user=login+pass=password+cmd=command
Note: If you use the password not in http: command you will need to enter it when the browser asks for the password.
a.) Set Power Command
The Set Power command allows you to control the devices on/off through the http commands. With this command you can integrate can integrate the 9258xx with any other system.
Command format: http://ip:port/set.cmd?cmd=setpower+p61=1 +p62=0+p63=1+p64=1
Outlet
Output 1
Output 2
Output 3
Power On
61 = 1
62 = 1
63 = 1
Power Off
61 = 0
62 = 0
63 = 0
64 = 0 Output 4 64 = 1
Ex. For 4 Ports Control On / Off
http://192.168.1.3/set.cmd?cmd=setpower+p61=1 +p62=0+p63=1+p64=1
Output: p61=1 p62=0 p63=1 p64=1
Ex. For Single Port Control Off
http://192.168.1.3/set.cmd?cmd=setpower+p61=0
Output:P61=0 b.) Read Power Command
1. Set Port On/Off http://192.168.1.3/set.cmd?cmd=setpower+p61=1 (relay open) , setpower+p61=0(relay closed)
- 26 -
advertisement
Related manuals
advertisement
Table of contents
- 4 1. INTRODUCTION
- 5 SPECIFICATION
- 6 3. INTERFACE DESCRIPTION
- 7 HARDWARE & SOFTWARE INSTALLATION
- 8 5. INITIAL SETTINGS
- 11 6. HARDWARE CONTROL & SETTINGS
- 12 7. CONTROL & SETTINGS
- 26 8. SNMP – MIB TREE
- 27 9. HTTP COMMAND & TELNET
- 27 a.) Set Power Command
- 27 b.) Read Power Command
- 28 c.) Power Delay
- 28 d.) Read Schedule
- 29 e.) Setup Schedule
- 29 Read current value
- 30 TELNET
- 31 10. FAQ