- No category
advertisement
UNCLASSIFIED
3.4 Applying Additional Control Markings
Choose the appropriate tabs to apply dissemination controls and other markings. The control markings available vary depending upon the classification and access controls selected. Be sure to select all options that apply.
Three of the four tab(s) are available in Portion Marking mode:
1.
SCI and Special Access
2.
Dissemination Controls
3.
Non-Intel and FGI
(See Figures 3-6 through 3-8)
Note: The
Derived From
tab is not enabled in the portion marking mode.
The dissemination and control tabs look the same in Portion Marking mode and
Banner/Header and Block mode.
Figure 3-6 SCI and Special Access Options
Select
Dissemination Controls
,
Figure 3-7 Dissemination Control Options
Classification Management Tools – Agency Automated Classification Guide User's Manual
UNCLASSIFIED
12
advertisement
Related manuals
advertisement
Table of contents
- 4 CMT Toolbar Overview
- 4 Microsoft Office Products
- 5 Lotus Notes Email Application
- 5 Toolbar Options
- 5 MS Office Products
- 5 Lotus Notes
- 6 Interface Overview
- 6 Portion Marking Mode Interface
- 7 Banner and Block Mode Interface
- 9 Use Quick Buttons to Apply Portion Marks
- 10 Launching Portion Marking Mode
- 10 MS Office Products
- 10 Lotus Notes
- 11 Basic Steps in Portion Marking Mode
- 12 Applying Additional Control Markings
- 13 Portion Marking Caveat
- 13 Portion Marking Waiver
- 14 Launching Banner and Block Mode
- 14 Marking Classified Documents
- 17 Applying Additional Control Markings
- 18 Using Your Agency's Guide
- 19 Using a Source Document
- 20 Marking Unclassified Documents
- 21 Launching V-PM Mode
- 21 Review and Modify Discrepancies
- 21 Unmarked Portion Discrepancy
- 22 Invalid Marking Discrepancy
- 23 Banner vs. Portion Marking Discrepancy
- 25 Add to Favorites
- 26 Apply a Favorite to Your Document
- 26 In MS Office Applications (including Outlook)
- 26 In Lotus Notes
- 27 Delete/Rename a Favorite