Configuring Event Settings. Lorex LH030 ECO BLACKBOX3 SERIES, LH03081TC4

17 Using the PC/Mac Client Software

17.31

Configuring Event Settings

The Event Settings tab allows you to configure how the system behaves when a system event occurs (e.g. hard drive error, video loss). This is useful if you want your DVR to notify you if there is a potential system problem.

To configure the system event settings:

1. Click the Remote Setting tab, and click Advanced>Events.

2. Configure the following:

• Event Type: Configure the type of event that triggers the system to send an alert.

• Enable: Select Enable to activate the system to notify you if an event occurs.

• Buzzer: Select OFF to enable/disable the system buzzer or select the duration of the system buzzer after an event occurs.

• Show Message: Select the checkbox to enable the system to display a warning message when an event occurs.

• Send Email: Select the checkbox to enable email notifications. Email notification must be enabled.

• Alarm Out: Select Enable for the system to trigger alarm out devices when an event occurs (alarm devices required; not included).

• Latch Time: Configure the system latch time after an event occurs.

3. Click Save to save changes.

#LX400008; r. 2.0/12067/12067; en-US

94