21.3.3 Selecting PTZ Presets. Lorex LH030 ECO BLACKBOX3 SERIES, LH03081TC4

21 Connecting a PTZ Camera (LH030 Series)

2. (Optional) In the Time field, select the number of seconds the camera will remain in that position during PTZ cruise before going to the next position.

3. Click Set to set the preset. The Total and No. field will automatically increase. The Total field shows you the total number of created presets, and the No. field shows you the number of the preset you are currently creating.

4. Complete the steps above to create additional presets as needed. Press Save when you are finished to save all created presets.

21.3.3

Selecting PTZ Presets

1. In the No. field, select the number of the preset you would like to select.

2. Click Go to to go to the preset.

21.3.4

Deleting PTZ Presets

1. In the No. field, select the number of the preset you would like to delete.

2. Click Clear to delete the preset and click Save to save your changes.

21.3.5

Starting / Stopping PTZ Cruise

When PTZ cruise is enabled, the camera will cycle through saved presets. You must set and save presets to use PTZ cruise.

To start / stop PTZ cruise:

1. Right-click to open the Menu Bar and click the Start Cruise button ( ). Enter the system password. The camera will cycle through PTZ presets.

• To stop the PTZ cruise, right-click to open the Menu Bar and click the Stop Cruise button ( ). Enter the system password.

#LX400008; r. 2.0/12067/12067; en-US

134