SRX Manual, v.5.023

i³Server

5.

Set the Post Recording time between 1 and 60 s. In this example, the camera(s) will record for 60 seconds after the Sensor is activated or after the detected motion stops.

Note

Motion and Schedule Setups must be configured.

To customize the Alarm for Sensor activation, do the following:

1.

Record the sound file in the WAV format

2.

Save the file in the WAV folder located in the i3DVR_Server folder

3.

In the Sensor Setup, type the WAV- source file name with the file extension in the Sound

File field. In the above example, the customized WAV files are chosen for Sensors 1-5.

Related Topics: Camera Setup | Control Setup | Preset Touring | Schedule Setup | Communic-

ation Setup | Server Information | System Setup | E-Map Setup | Email Setup

Hardware Setup - Control Setup

Overview

Control settings are applicable only if controls are available and are being used.

Active Time

Active Time refers to the designated time when the control is active (is on). The default setting is 00:00-00:00, which means the control is always off. The control will be continuously on, if the

Active Time is set to 00:00 - 24:00. During the Active Time, the control cannot be turned off from the main screen. Outside of the Active Time, the control can be activated by sensor, or manually from the main screen.

Dwell Time

Dwell Time is the time that the control will stay turned on when it is sensor-triggered. This does not apply if the control is turned on manually from the main screen. In other words, if the control

18

XML to PDF by RenderX XEP XSL-FO Formatter, visit us at

http://www.renderx.com/