4 - Emulator Features
4.6
ST7MDT5-EMU2B Emulator User Manual
Front Panel LEDs
Four LEDs on the front panel of the HDS2 box indicate the state of the development tool during emulation:
• Power (Green)—indicates that the 5 V power supply is ON.
• Run (Yellow)—indicates that the ST7 is running (not in RESET, WFI and HALT mode).
• System (Red)—not used with this emulator.
• Reset (Red)—not used with this emulator.
Analyser
Probe
ST7 HDS2 Emulator
Power
Run
Unused
Reset
Triggers
You can configure certain on-chip peripherals in ST7 Visual Debug’s MCU
Configuration dialog box (refer to Creating a workspace on page 26) so that the emulator accurately emulates your target device.
The on-chip peripheral options supported by the emulator are:
4.7.1 CLOCK
The emulator can work with six clock sources (Max. Frequency = 16 MHz, Min.
Frequency = 1 MHz):
• 16 MHz internal oscillator.
50/65
