TimeClock Plus 4.1
5
Getting Started with TimeClock Plus
The contents of this section will guide you through the initial setup of your TimeClock Plus software and hardware.
Installing the TimeClock Plus Software
Adding Users
Adding Job Codes
Setting up Tracked Fields
Setting the Pay Frequency
Setting Up Accruals
Creating Templates
Adding Miscellaneous Information
Installing the Single User Version of TimeClock Plus 4.1
Note: If you are upgrading from a previous version of TimeClock Plus and wish to update your information to Version
4.1, you should make a backup of your current data directory.
The single user version of TimeClock Plus can be installed by running the
setup.exe program found on the TimeClock Plus
CD-ROM.
1) Insert the TimeClock Plus CD-ROM into your CD-ROM drive.
2) If auto-run is enabled a menu will appear. If it is not enabled, click on the
Start menu and select Run. Enter X:\SETUP in the program name and click the
OK button (where X: is the drive letter of your CD-ROM drive).
3) Click on
Install TimeClock Plus Server/Single User to launch the InstallShield Setup Wizard.
4) Enter your company information and serial number which can be located serial number
5) Select the Destination folder to which you will be installing the software. If you are upgrading from version 3.0, you can install 4.1 into the same directory. If you are upgrading from a version prior to 4.1 or you would like to continue to use your previous version, you should install TimeClock Plus 4.1 into a different directory.
6) Select the components to install on your system. By default all items are selected for install. These are the recommended selections.
The InstallShield Wizard will complete the set up of TimeClock Plus Version 4.1 on your system.
Once the system is installed, you should launch TimeClock Manager to configure TimeClock Plus. Log into TimeClock
Manager using the SUPERVISOR user ID to perform the initial configuration. After the first log in you will be prompted to run the Quick Setup Wizard. For more information on running this wizard, refer to page 6.
