- Firmware uživateľská príručka, V6.04.15

Firmware User

’s Manual V6.04.15

Network

The section

Network

provides the list of network related functions and services. The [+] mark before Network indicates that the list can be expanded by clicking on it.

Once expanded, the list can later be collapsed again by clicking on the [-] mark.

IP Address Filtering

By

“IP Address Filtering”

function it is possible to define which devices (their IP addresses) are allowed to connect to this camera, and which devices are forbidden to connect to this camera.

Check the box

“Enabled” to activate the IP address filtering function and press Apply.

Below you can select either

“Allowed” or “Blocked” list to add items there and Enable them with the checkbox behind each row.

21 www.acti.com

Firmware User

’s Manual V6.04.15

“Allowed”

mode will refuse access to all IP addresses except the ones listed below.

“Blocked”

mode will accept all incoming access except the IP addresses listed below.

Using

Netmask

(Subnet Mask) allows you to set filtering for a whole range of IP address at once, without the need to enter all of them individually. If you are not sure about the function of Netmask, then you should use 255.255.255.255, and it will affect only a single IP address per line of entry, or use 255.255.255.0 to use the same setting for all IP addresses starting with the same three numbers. .

After changing any of the items above, press

Apply

to save the changes. The Reset button undoes the changes that had just been made but not Applied yet.

Warning!

Do not accidentally block your own IP address that you are connecting from; otherwise you will not be able to access the camera any more to undo the changes. If this happens by mistake, you can do the hardware reset

– it will clear all the filtering rules.

22 www.acti.com