COMPLETE INSTALLATION. Maytag 29", MGD5700TQ, MED5591TQ0

COMPLETE INSTALLATION

1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

6. Remove any protective film on the console and any tape remaining on the dryer.

7. Dispose of/recycle all packaging materials.

2. Check that you have all of your tools.

3. Check the dryer’s final location. Be sure the vent is not crushed or kinked.

4. Check that the dryer is level. See “Level Dryer.”

8. Read “Dryer Use.”

9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

WARNING

10. Select a Timed Dry heated cycle, and start the dryer. Do not select the Air Only

Temperature setting.

If the dryer will not start, check the following:

■

Dryer is plugged into a grounded 3 prong outlet.

■

Electrical supply is connected.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

■

■

Household fuse is intact and tight, or circuit breaker has not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close door. If you do not feel heat, turn off the dryer and check that the gas supply line shutoff valve is open.

■

If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above.

■

If the gas supply line shutoff valve is open, contact a qualified technician.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

5. Plug into a grounded 3 prong outlet. Turn on power.

14