Configuration language. Fagor CNC 8055 para otras aplicaciones, CNC 8055 for lathes, CNC 8055 para fresadoras, CNC 8055 for milling machines, CNC 8055 para tornos, CNC 8055 for other applications

15.

Installation manual

15.2

Configuration language

The general characteristics of the configuration language are:

• All instructions are preceded by ";" and enclosed in parenthesis.

• The comments must be alone and preceded by ";;"

• The configuration file must begin with the line ;(PRGSCRIPT 1)

• It indicates that it is a configuration file corresponding to the version being used (in this case "1")

• The configuration file should end with the line ;(END)

• While debugging the program, the ;(DEBUG) instruction should be used

• If an error occurs while checking the configuration file, the CNC will inform about it in program

999500.

The configuration language consists of:

• A series of key words or tokens.

• The names of the internal CNC variables.

• Numbers that may be associated with the previous two items.

• Various punctuation signs.

Example of a configuration file:

;(PRGSCRIPT 1)

;;==================================

;; SCREEN LAYOUT

;; Screen in JOG mode - Actual

;;==================================

;[JOG],PLCM1125

;(DEBUG)

;(DISABLE 0)

;(WGDWIN 201)

;;--------------------- X axis, coordinate, error and consumption

;(AUTOREFRESH W1=POSX)

;(AUTOREFRESH W2=FLWEX)

;(FORMAT W3,LEDBARDEC)

;(AUTOREFRESH W3=ANAI1)

;;-------------------- Z axis, position, error and consumption

;(AUTOREFRESH W4=POSZ)

;(AUTOREFRESH W5=FLWEZ)

;(FORMAT W6,LEDBARDEC)

;(AUTOREFRESH W6=ANAI2)

;;-------------------- Feedrate, F, %

;(AUTOREFRESH W7=FEED)

;(AUTOREFRESH W8=FRO)

;;-------------------- Spindle, S, Smax, %

;(AUTOREFRESH W9=SPEED)

;(AUTOREFRESH W10=SLIMIT)

;(AUTOREFRESH W11=SSO)

;;-------------------- Tool and offset (T, D)

;(AUTOREFRESH W12=TOOL)

;(AUTOREFRESH W13=TOD)

;(END)

CNC 8055

CNC 8055i

S

OFT

: V01.6

X

·572·