11" LCD Monitor. Fagor CNC 8055 para otras aplicaciones, CNC 8055 for lathes, CNC 8055 para fresadoras, CNC 8055 for milling machines, CNC 8055 para tornos, CNC 8055 for other applications

Installation manual

Digital inputs

Rated voltage +24 V DC.

Maximum rated voltage +30 Vdc.

Minimum rated voltage +18 Vdc.

High threshold (logic level "1") V

IH

: From +18 V DC up.

Low threshold (logic level "0") V

IL

: Under +5 Vdc or not connected.

Typical consumption of each input 5 mA.

Maximum consumption of each input 7 mA.

Protection by means of galvanic isolation by optocouplers.

Protection against reverse connection up to -30 Vdc.

Digital outputs

Rated supply voltage +24 Vdc

Maximum rated voltage +30 Vdc.

Minimum rated voltage +18 Vdc.

Output voltage V out

= Supply voltage (Vdc) - 3 V

Maximum output current 100 mA

Protection by means of galvanic isolation by optocouplers.

Protection through an external 3 A fuse against reverse connection up to -30 Vdc and against over-voltage of the external power supply greater than 33 Vdc.

Analog inputs

At the –Vpp axes– and –Vpp SB axes– modules, voltage within the ±5 V or ±10 V range (may be selected by machine parameter).

Resolution 46.8 mV.

Shielded cable should be used.

Analog outputs

Command voltage within ±10 V.

Minimum impedance of the connected connector 10 k

.

Shielded cable should be used.

5 V probe input.

Typical value: 0.25 mA.

 Vin = 5 V.

High threshold (logic level "1") V

IH

: From +2.4 V DC up.

Low threshold (logic level "0") V

IL

: Under +0.9 V DC.

Rated voltage Vimax = +15 V DC.

24 V probe input.

Typical value: 0.30 mA.

 Vin = 24 V.

High threshold (logic level "1") V

IH

: From +12.5 V DC up.

Low threshold (logic level "0") V

IL

: Under +4 V DC.

Rated voltage Vimax = +35 V DC.

B.

CNC 8055

CNC 8055i

S

OFT

: V01.6

X

·627·

B.

Installation manual

CNC 8055

CNC 8055i

S

OFT

: V01.6

X

·628·