advertisement
Firmware User
’s Manual V6.05.xx
Audio
The section
Audio
is available only for audio-supported models. The user interface for audio control looks as below:
Parameters
Audio In
Audio In
Sensitivity
Audio Out
Volume
Audio Format
Description
The option
“Enabled” would activate incoming audio (either line in or built-in microphone). The option
“Disabled” would turn off the incoming audio. In such case, the video stream is captured without audio.
Cho ose “High” when the target is farther away from the camera and choose
“Low” when the target is near the camera. Under “High” mode, there may be more audio noise due to higher level of signal amplification.
The audio out volume level can be adjusted in the scale of 0-100. It will influence the volume level of the speakers connected to the camera.
Choose the compression format of audio: PCM, G.711A (
A-law
) or G.711U
(
µ-law
).
To adjust the volume level of the speakers connected to the PC that runs the Web Configurator in order to hear the audio from the camera
’s microphone or line-in device, go to
Live View
page and use the audio controls there:
Audio Muted:
Audio level adjusted to the maximum:
This volume control appears in user interface only when the Audio-in function of the camera has been
“Enabled”.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 6 Connect the Equipment
- 6 Configure the IP Addresses
- 10 Access the Camera
- 12 Login
- 13 Live View
- 17 View Modes
- 18 ePTZ View Mode
- 19 Panorama View Mode
- 20 Fisheye View Mode
- 21 PTZ Control Panel (For PTZ and Zoom Cameras)
- 21 How to Use Pan/Tilt
- 22 How to Zoom the Camera In or Out
- 23 How to Set the Home Position
- 23 How to Set Serial Hex Command Protocol
- 23 How to Adjust the Focus
- 24 How to Set Touring Preset Points
- 24 How to Set and Enable Tours
- 26 Access the Setup Page
- 28 Date & Time
- 30 Network
- 30 IP Address Filtering
- 32 Port Mapping
- 34 HTTPS
- 35 IEEE 802.1X
- 37 SNMP Setting
- 41 Network (ToS, UPnP, Bonjour, ONVIF)
- 44 IP Settings
- 44 Connection Type
- 50 Video & Audio
- 50 Camera Options on Fisheye Cameras
- 51 Camera Options on 1.3MP Cameras
- 52 Compression
- 55 Motion Detection
- 60 Day/Night
- 61 Image
- 63 Exposure / White Balance
- 67 OSD/Privacy Mask
- 70 On-Screen Graphics
- 72 Audio
- 73 Event
- 73 Event Server
- 76 Event Configuration
- 83 Event List
- 86 Manual Event
- 87 Local Storage Management
- 88 Status
- 89 Utilities
- 94 Setup
- 95 File Management
- 101 Event Handler with Local Storage
- 108 System
- 108 User Account
- 109 System Info
- 110 Factory Default
- 111 Firmware Upload
- 112 Save & Reboot
- 113 Logout