- Computers & electronics
- Computer components
- System components
- Server/workstation motherboards
- User manual
![](http://s3.manualzz.com/store/data/032423228_1-2071a470cb6531f2f228a83a5c24ab03-128x128.png)
advertisement
▼
Scroll to page 2
of
141
![Silicon Graphics® Zx10 Visual Workstation Owner`s Guide | Manualzz Silicon Graphics® Zx10 Visual Workstation Owner`s Guide | Manualzz](http://s3.manualzz.com/store/data/032423228_1-2071a470cb6531f2f228a83a5c24ab03-360x466.png)
10: System Hardware and Specifications
System Specifications
Table 10-18
System Specifications
Item Specifications
Dimensions 21 in high x 8.75 in wide x 20.75 in deep
(53.3 cm high x 22.2 cm wide x 52.7 cm deep)
55 lb (25 kg) fully configured Weight
AC line voltage (US) 90 – 132 VAC, 47 – 63 Hz, 1 phase, 15A/125 V receptacle
AC line voltage (International) 180 – 264 VAC, 47 – 63 Hz, 1 phase, 15A/250 V receptacle
Power consumption
Recommended room temperature
285 W; 3.4 A at 120 VAC maximum configuration
50
°
to 90
°
F (10
°
to 32
°
C); optimum 70
°
F (21
Recommended room humidity 20% to 80% (non-condensing); optimum 50%
°
C)
Heat dissipation 973 BTU/hr
136 007-4327-002
advertisement
Related manuals
Download
PDF
advertisement
Table of contents
- 21 Unpacking the System
- 22 Placing System Components
- 22 Connecting System Components
- 25 Locating Expansion Cards
- 26 Connecting External SCSI Devices
- 28 Connecting to AC Power
- 29 Starting the System
- 30 What’s Next?
- 31 Preparing for Setup
- 33 Going Through Setup
- 35 Finishing Software Setup
- 36 Installing the Network Controller Driver
- 36 Creating an Emergency Repair Disk
- 36 Installing Driver Software
- 37 Installing QFE Software
- 37 What’s Next?
- 39 Configuring the Video Display
- 39 Resetting the Video Display Resolution
- 40 Changing the Default Video Display Driver
- 40 Correcting Initial Video Display Problems
- 41 Configuring System Audio
- 41 Configuring Networking
- 42 Configuring Peripheral Devices
- 42 Changing Drive Letters
- 43 Changing Virtual Memory Settings
- 44 Configuring the SCSI Controller
- 44 Creating or Updating an Emergency Repair Disk
- 45 Configuring the BIOS
- 45 What’s Next?
- 47 Opening and Closing the Door
- 48 Controlling System Power
- 50 Reading System LEDs
- 52 Using Automatic Shutdown
- 53 Starting and Stopping the Operating System
- 54 Observing Operating Precautions
- 54 Using the Keyboard
- 56 Using the Mouse
- 58 Using the Floppy Disk Drive
- 58 Using the CD-ROM Drive
- 59 Using System Management Software
- 59 Learning About the Operating System
- 60 Using Hardware Security Features
- 60 Cleaning System Components
- 61 Getting Started
- 62 System Power
- 62 System Boot
- 66 Video
- 66 Audio
- 67 Network
- 67 Peripheral Drive Errors
- 68 Miscellaneous Hardware
- 71 Before You Begin
- 71 Finding Driver Software
- 72 Installing the Operating System
- 73 Updating the Operating System
- 75 Before You Begin
- 76 Avoiding Electrostatic Discharge
- 76 Removing and Replacing Side Panels
- 78 Removing and Replacing the Faceplate
- 79 System Components
- 81 Before You Begin
- 82 Adding Expansion Cards
- 83 Identifying Expansion Card Slots
- 84 Installing an Expansion Card
- 85 Assigning System Resources
- 85 Disabling On-Board Controllers
- 86 Adding External SCSI Peripheral Devices
- 86 Choosing SCSI Cables
- 87 Choosing SCSI IDs
- 87 Terminating SCSI Devices
- 88 Connecting SCSI Devices
- 89 Changing SCSI Controller or Device Settings
- 89 Adding Internal Peripheral Devices
- 92 Adding Memory
- 92 Upgrading Processors
- 93 Before You Begin
- 94 Floppy Disk Drive
- 95 Front-Access Peripheral Device
- 99 Internal-Access Peripheral Device
- 102 Expansion Card
- 105 Memory Module
- 106 Processor Bus Terminator
- 107 Processor Module
- 107 Power Supply
- 110 Cooling Fans
- 113 System Board
- 115 CMOS/Clock Lithium Battery
- 116 Chassis Intrusion Alarm Switch
- 117 Power Switch, System LEDs, and Light Pipe
- 121 Functional Diagram
- 122 Internal Peripheral Cabling
- 123 EIDE Cabling
- 123 SCSI Cabling in a Zx10 System
- 124 SCSI Cabling in a Zx10 VE System
- 126 Floppy Disk Drive Cable
- 126 EIDE Device Cables (Installed and Optional)
- 127 Internal-Access Device SCSI Cable
- 127 External SCSI Port Cable
- 128 Internal/External SCSI Cable
- 128 Internal/External SCSI Cable (Zx10 VE)
- 129 Power Supply and Cables
- 129 300 Watt Power Supply
- 131 400 Watt Power Supply
- 133 Cooling Fans
- 134 Hardware Monitoring and Power Management
- 134 System Configuration Summary
- 136 System Specifications
- 137 Setting Your Work Habits
- 137 Getting Started
- 138 Wrists
- 138 Head and Eyes
- 139 Setting Your Environment
- 140 Reducing the Risk of Injury
- 140 Changing Posture
- 140 Taking Rest Breaks
- 141 Taking Care of Your Body
- 141 Getting Help