advertisement
Sent out in a configurable interval.
This Notification is always sent out, as soon as SNMP and the alarm traps are activated and a destination address is configured.
The Notification sent out contains the following data: dts4148SysStatus Unsigned Int 4 Bytes Contains the internal system status dts4148SysAlarms Byte Array 8 Bytes 64 Bit Alarm flags
1.Byte Bit 0..7
2.Byte Bit 8..15
::
8.Byte Bit 56..63
66309
FFF870FF.FFFFFFFF
¦ ¦ ¦
¦ ¦ 5.Byte
¦ 2.Byte
1.Byte
[dts4148Alarm]
Sent out if alarm status changes, i.e. Notification is sent out when an alarm flag is set or deleted.
This Notification is always sent out, as soon as SNMP and the alarm traps are activated and a destination address is configured.
The Notification sent out contains the following data: dts4148TrapAlMsgErrorNr Byte dts4148TrapAlMsgErrorTime Unsigned
Int dts4148TrapAlMsgErrorText Text
1 Byte No. of the alarm bit (0..63) 3
0 = alarm bit was deleted
1 = alarm bit was set
1
946684805
4 Bytes PC-time in seconds since
01.01.1970 00:00:00
59 Bytes Error text
Failure supply 1
© MOBATIME 78 / 108 801053.02
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- - Safety
- - Maintenance
- - General Information: Introduction
- - Displays
- - Installation
- - Operation
- - Updates
- - Time administration
- 4 Power supply alternatives
- 5 Connection diagrams
- 9 Time zone table
- 12 Alarm list
- 14 Troubleshooting
- 16 Serial Telegrams
- 21 Copyright Notice
- 22 Parameters
- 27 Technical data
- 30 Index
- 32 Connection table (to fill in)
- 6 Safety
- 6 Safety instructions
- 6 Instruction Manual
- 6 Intended Use
- 7 Observe operating safety!
- 7 Consider the installation site!
- 7 compatibility!
- 8 Maintenance
- 8 Troubleshooting: Repairs
- 8 Cleaning
- 8 Disposing
- 9 General Information: Introduction
- 9 Scope of Delivery
- 9 Technical Data
- 9 Device Description in this Manual
- 9 Introduction
- 10 Device types
- 10 DTS Distributed Time System
- 10 MOBA-NMS - Network Management System
- 11 Overview of the main functions
- 12 Device management
- 13 Displays
- 13 LED displays front side
- 13 LED indication back side
- 14 Display
- 15 Installation
- 15 Connections
- 15 Initial configuration
- 15 Firmware
- 15 Basic settings (factory settings)
- 16 Operation
- 16 General
- 16 Telnet
- 17 Menu structure
- 18 MOBA-NMS operation
- 19 Main menu
- 20 Status menu
- 22 Time information and status
- 23 Time source information
- 24 Configuration menu
- 25 Lines
- 25 DCF – output
- 26 DCF / Pulse / Frequency output
- 27 Serial interface
- 29 IRIG / AFNOR / DCF-FSK Output
- 30 NTP slave clocks / time zone server
- 32 SINEC
- 32 Time handling
- 33 Time source
- 34 Time adjustment / Time-keeping
- 35 Redundant operation
- 36 NTP server
- 40 Manual time set / Leap second
- 41 PTP Server
- 43 Alarms
- 43 Alarm relay
- 44 Alarm mask
- 45 E-mail
- 47 SNMP traps
- 49 Alarm input
- 50 General settings
- 51 Network
- 53 Services (network services FTP, telnet, SSH...)
- 55 SNMP V1 / V2c
- 56 SNMP V
- 59 Time zone selection
- 60 Maintenance menu
- 61 Updates
- 61 Updating images with MOBA-NMS
- 61 Updating images with FTP
- 62 Updating images via USB
- 64 FTP connection
- 64 SFTP connection
- 65 SCP connection
- 65 Save Configuration externally
- 66 4148.grandmaster
- 67 Time administration
- 67 Concept of time administration
- 68 Time acceptance
- 68 (DCF or GPS)
- 69 IRIG-B12x source
- 69 Time acceptance from NTP
- 69 NTP as backup
- 69 Time server
- 70 Time accuracy, time-keeping
- 70 Leap second
- 70 NTP Authentication
- 70 NTP symmetric keys
- 71 NTP Autokey
- 73 4148.grandmasters
- 75 General
- 76 Device configuration with SNMP
- 76 DTS subagent SNMP notification
- 76 Startup [dts4148StartUp]
- 76 Shutdown [dts4148Shutdown]
- 77 Status changed [dts4148StatusChanged]
- 77 [dts4148ConfigChanged]
- 78 Alive Notification [dts4148Alive]
- 78 Alarm Notification [dts4148Alarm]
- 79 Power supply alternatives