Installing the CSX200. Cabletron Systems CyberSWITCH CSX203, CyberSWITCH CSX202, CSX200 CyberSWITCH, CyberSWITCH CSX201

Installation

Installing the CSX200

The CSX200 may be installed on a tabletop, shelf or in a 19-inch rack.

Refer to Tabletop and Shelf Installations for information concerning a tabletop or shelf

installation. CSX200 Rackmount Installation describes the rackmount installation.

Tabletop and Shelf Installations

The following two subsections provide guidelines for installation on a tabletop or shelf.

!

CAUTION

Before performing tabletop or shelf installation procedures, ensure that the requirements outlined in the section,

Guidelines for Installations , on page 25, are met.

To install the CSX200 on a tabletop or shelf, locate the CSX200 within seven feet of its power source with an unrestricted free surface area as shown in

Figure 7

, and complete the following steps:

1.

Locate the six round rubber feet included with your CSX200.

2.

Peel the paper backing off the round rubber feet, and adhere them to the bottom of the CSX200.

Place one rubber foot near each of the four corners of the CSX200, and evenly space the remaining two near the center.

21 IN.

6 IN.

18 IN.

7 FT.

2012_07

Figure 7 Tabletop or Shelf Installation

Continue the installation by connecting power as described in

Connecting the CSX200 to the

Power Source .

CSX200 Family User’s Guide 31