HDSL Physical Configuration. Cabletron Systems CyberSWITCH CSX203, CyberSWITCH CSX202, CSX200 CyberSWITCH, CyberSWITCH CSX201

WAN Configuration Using Local Management

HDSL Physical Configuration

To configure the WPIM-HDSL for the CSX200, access the WAN Physical Configuration screen

for the WPIM-HDSL, shown in Figure 78 , by using the arrow keys to highlight the WAN SETUP

menu item on Setup Menu screen (refer to

Chapter 6

), and pressing ENTER. The WAN Physical

Configuration screen displays.

Local Management

WAN PHYSICAL CONFIGURATION

Flash Image Version XX.XX.XX

WPIM 1

Type: HDSL

BRIM #: 1

Mode: [Primary]

Active: Yes

Ifaces: 003-026

WPIM 2

Type: T1

BRIM #: 2

Mode: [Primary]

Active: Yes

Ifaces: 027

WPIM 1 Line Configuration

HDSL Tx Clock Source: [Loop-Timing]

HDSL Timeslot Configuration: [Fractional]

SAVE [WPIM 1] WAN INT CONFIG

Figure 78 WAN Physical Configuration Screen

RETURN

168 CSX200 Family User’s Guide

WAN Configuration Using Local Management

WAN Physical Configuration Screen Fields

The following list describes the WAN Physical Configuration screen fields.

WPIM # — Displays configuration information for the WPIMs that are installed.

Type — Displays the WPIM type.

BRIM # — Displays the BRIM slot in which the WPIM resides.

Mode — Displays the WPIM mode.

Active — Displays the status of the WPIM.

Ifaces — Displays the interfaces available to each WPIM.

WPIM-HDSL Configuration Fields

HDSL Tx Clock Source — Displays the HDSL Transmit Clock Source. The selections for this field toggle between Loop-Timing (Extracted Line Data) and Local-Timing (Internal Clock). The default setting for this field is Loop-Timing.

NOTE

The Loop-Timing selection in this Local Management screen corresponds to the Slave selection in the QuickSET HDSL WAN Configuration window; the Local-Timing selection corresponds to the Master selection.

HDSL Timeslot Configuration — Displays the timeslot configuration for the WPIM. The selections for this field toggle between Full and Fractional. The default setting for this field is Full.

Full uses all 24 timeslots and Fractional uses the first 12 timeslots.

CSX200 Family User’s Guide 169