Configuring Low Ink Warnings. Pitney Bowes DM800

5 • Mailing System Setup

10

Configuring

System

Timeouts

This section describes how to set various system timeouts for your mailing system.

1. To access the system timeouts, press the Menu key on the control center, and select Set Up.

2. Select Basic Settings and then

Timeouts to get all of the timeout options.

The timeout options are listed on the right.

All of these options are described in the following sections.

Timeouts

► Display Sleep

► System Sleep

► Normal Preset Timeout

► Feeding Timeout

► Waiting for Env

► Transaction Timeout

Timeouts:

Display Sleep

This option allows you to specify how long the system can remain inactive before the display turns off. You can set the timeout for 1 - 30 minutes, in 1 minute increments. The default timeout is 5 minutes.

The display turns on again when you press any key on the control center or if you place mail in the feeder or on the scale (either integrated or attached external scale).

1. Press the Menu key and select Set Up.

2. Select Basic Settings and then Timeouts.

3. Select Display Sleep.

4. Enter the number of minutes (1-30) using the numeric keyboard.

5. Press the Enter key.

5-18

Timeouts:

System Sleep

This feature may be offered as a standard or optional feature and is not available on all Pitney Bowes solutions. Please contact your local account representative to determine if this option is accessible on your system.

Use this option to specify how long the system can remain inactive before it goes into “deep-sleep” and removes power from the printer and the

Postal Security Device (PSD).

You can set this timeout for 0 - 1440 minutes, in 1 minute increments. The default timeout it 30 minutes. The system goes into display sleep before it goes into system sleep.

The system wakes up again when you press any key on the control center or if you place mail in the feeder or on the scale (either integrated or attached external scale).

1. Press the Menu key and select Set Up.

2. Select Basic Settings and then Timeouts.

SV61162 Rev. C