AllSync Plus Clock Installation & Operation Guide

AllSync Plus Clock Installation

& Operation Manual

Installation

Plastic Surface Mount Clock Installation

Warning:

The AllSync Plus plastic surface mount clock should be mounted according to these instructions to meet

UL clock listing.

1. Remove the AllSync Plus clock, mounting bracket, and wiring harness

(if applicable) from the packaging.

2. Using UL approved wire nuts, make connections between flying leads and wiring inside electrical box. a. Black wire should be connected to hot (run) wire from the master. b. Red wire should be connected to the correction line from the master

clock.

c. White wire should be connected to the neutral line.

d. Green wire should be connected to earth ground.

Note: All wiring connections should be made in accordance to local and national electrical codes.

3. Bundle all wall wiring and female connector wiring inside back box and place mounting bracket over back box opening.

4. Attach mounting bracket to back box and wall, ribbed post up.

5. Secure bracket to wall using appropriate mounting screw and anchor for wall material. Screw and anchor are not included.

© American Time

7

8

Installation

AllSync Plus Clock Installation

& Operation Manual

Plastic Surface Mount Clock Installation (cont)

6. Make connection between clock and wall wiring using attached four conductor mating connectors.

7. Bundle wires inside clock bezel.

8. Slide keyhole hanger over ribbed hanging stem on mounting bracket

General Operation

9. Screw bottom portion of clock to mounting bracket

Note: Screw bottom portion of the clock to the point the screw bottoms out.

Do not over tighten.

Caution:

Over tightening may damage clock bezel. If the clock bezel begins to deform, cease tightening.

© American Time