INSTALLATION INSTRUCTIONS COMMERCIAL DRYER INSTRUCTIONS POUR L’INSTALLATION D’UN SECHE-LINGE COMMERCIAL

ELECTRONIC CONTROL SETUP

See the programming guide for information on setup.

MAINTENANCE INSTRUCTIONS

Maintenance instructions:

n

Clean lint screen after each cycle.

If dryer does not operate, check the following:

n

Electric supply is connected.

n

Removing accumulated lint (disconnect dryer from electricity and gas supply before starting this task): n

Circuit breaker is not tripped or fuse is not blown.

n

Door is closed.

•

From inside the dryer cabinet:

Lint should be removed every 2 years or more often, depending on dryer usage. Cleaning should be done by a qualified person.

n

Controls are set in a running or “ON” position.

n

Cycle has been selected.

n

Check that gas supply shut-off valves are set in open position.

•

From the exhaust vent:

If you need assistance:

Lint should be removed every 2 years, or more often, depending on dryer usage.

Contact your authorized Maytag

®

Commercial Laundry distributor or visit: www.MaytagCommercialLaundry.com. When you call, you will need the dryer model number and serial number.

Both numbers can be found on the serial-rating plate located on your dryer.

REVERSING THE DOOR SWING (OPTIONAL)

You can change your door swing from a right-side opening to a left-side opening, if desired.

C

5. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed.

B

6. Attach door hinges to dryer door so that the larger hole is at the bottom of the hinge and the hinge pin is toward the door front.

A

1. Open dryer door. Remove bottom screws from cabinet side of hinges (A). Loosen (do not remove) top screws from cabinet side of hinges.

2. Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Remove top screws from cabinet.

3. Remove screws attaching hinges to door.

4. Remove screws from all sides of door (5 screws). Grasp sides of outer door and gently lift to separate it from inner door (do not pry apart). Do not pull on door seal or plastic door catch.

7. Remove the 4 screws that attach 2 plugs (B) on the handle side. Attach plugs to opposite side using the same 4 screws.

8. Insert screws into bottom holes on left side of cabinet. Tighten screws halfway.

Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.

9. Close door and check that door strike aligns with door catch (C).

10