ginlong SOLIS Single and Three Phase Meter User Manual

EXPORT LIMIT

SETTINGS

Single and Three Phase Meter

STEPS FOR SETTING UP EXPORT LIMIT

USING A METER

*Make sure the inverter has a Meter input port.

STEP 1 : Press Enter on the inverter screen.

STEP 2 : Use Up/Down keys to go to advanced settings and press Enter.

STEP 3 : Press Down key twice and up key once, to type the password as 0010. Then press Enter.

STEP 4 : Use the up/down keys to scroll to

Grid ON/ Grid OFF. Then press Enter.

STEP 5 : Select the Grid OFF option and press

Enter. You will see the operation light turn

OFF.

STEP 6 : Use Up/Down keys to scroll to EPM settings/ Internal EPM/ Export Power Set, whichever is available on your screen. Then press Enter.

Enter

Advanced Settings

Enter

Up and Down Keys

Enter

Up and Down Keys

Grid ON/ Grid OFF

Enter

Operation light turned OFF

Grid OFF

Enter

EPM Settings

Enter

STEP 7: Go to Soft Hard Limit Set and press

Enter.

Step 8: Choose Soft Backflow Power and press

Enter. Then set the export limit using the

Up/Down keys and press Enter to save. For example: 5kw export limit will be +5000 W.

STEP 9 : Use Up/Down keys to find Mode Select.

Press Enter.

It will be OFF at first. Use Up/Down keys to select ‘ Meter in Grid ’. Press Enter to Save and you will see a message on the screen as

“DONE!”.

Step 10 : For 1phase inverters only , go to

Meter Select, choose 1Ph.

Then select appropriate meter model name that you have installed.

STEP 11 : Now turn the Grid ON in Advanced

Settings.

(Go to Advanced Settings again by pressing ESC thrice < Set password 0010 < Go to Grid

ON/Grid OFF < Select Grid ON < Press Enter).

STEP 12: Press ESC to exit to the main screen.

The status displayed will be LYMBYEPM, which indicates you have successfully set up the export limit.

Note - Do not Turn OFF failsafe alarm. If you have any Failsafe alarm, it indicates issue with export setup and connections. Check the connections and make sure inverter is meter compliant .