Acclaim Lighting TC-1 U User manual

TC-1 E/U

F

D

US VERSION

USER’S MANUAL

24-004-3040-00

Rev1.0

GENERAL INFORMATION

You made the right decision by choosing this compact and easily operation dimmer unit. Every unit has been thoroughly tested and carefully packed before shipment. Unpack the shipping carton carefully, saving the carton and all packing materials for possible later use.

Check carefully for sure your product is not damaged and all accessories not missing. If your product appears to be damaged or missing, please do not use it and contact your local distributor immediately.

Please read this manual carefully and thoroughly, as it gives important information regarding safety, use and maintenance. Keep this manual with the unit for possible future reference.

PRODUCT FEATURES

512 DMX Output, all channels can be controlled by a touching fader

Infrared remote control function available

Up to 10 years storage in memory for data

Only for indoor use

0-10V Analog signal output, 3 mA max

TECHNICAL SPECIFICATION

Power Requirement

Power Output

Power Consumption

Drive Current

Control

IP Rating

Fuse

Physical Dimensions

Weight

DC12-24V

DC12-24V

2.4W max

200mA

DMX512

IP20

200mA

80(L) X 124(W) X 41(H) mm(US)

85(L) X 85(W) X 41(H) mm(EU)

120g(EU)/95g(US)

-1-

OPERATION GUIDE

Connect the device to a proper power outlet and poweron this unit, then the TC-1 is ready for use.

1. Power button

Tap the Power button to turn on the output while this unit is in standby status, the output will change to the desired value gradually as per the fadetime set.

Tap the Power button to turn off the output while this unit is on, the output will change to zero gradually as per the fadetime set.

Keep pressing the Power Button for 10s, this will allow users to change the way to power

ON/OFF this unit. Users can make it instant effort or 5s delay, when user select the instant effort, the device will response promptly(ON/OFF) when user tap the power button, while it will be effective after 5s when user select the 5s delay.

2. Fadetime Button

Tap the F button, the corresponding indicator will light up, indicating that this device is engaged in fadetime adjusting mode,users are allowed to set the fadetime via the fader within the range of 0.01s to 10s.

Tap the D button, the Dimmer indicator will light up, indicating that this unit is engaged in

Dimmer adjusting mode,

Tap the fader upwards and downwards to set the Dimmer value within the range of 0%-100%.

-2-

IR Control

TC1

DIM FADE

Before operating the device via the IR control, please fill the IR controller with CR2025 battery. Refer to the following table for relevant functions.

Button

POWER

DIM-

DIM+

FADE-

FADE+

INTENSITY

To power on/off

Function

Decrease the output intensity

Increase the output intensity

Decrease the fadetime, min=0.01s

Increase the fadetime, max=10s

Keep pressing the key until the intensity change to corresponding level

-3-