Installation workflow. Bosch Solution 2000, SOLUTION 3000

Control Panel

3

Installation workflow | en

13

Installation workflow

Before installing and operating the control panel, read these instructions. Failure to follow these procedures may cause the device not to function properly. Bosch Security Systems Inc.

is not responsible for any devices that are improperly installed, tested, or maintained.

This document does not contain special information about local requirements and safety issues. Information on such issues is provided only to the extent that it is needed for operation of the device. Ensure that you are familiar with all safety-related processes and regulations in your area. This also includes how to act in the event of an alarm and the initial steps to take if a fire breaks out. The operating instructions should always be available on site.

It is a required part of the system and must be given to the new owner if the system is ever sold.

Use the workflow and checkboxes below as you complete steps.

Install the enclosure

Install the control panel

Install and wire for telephone communication

Install and wire for IP communications

Install and wire the transformer

Install and wire arming devices

Install and wire outputs

Install and wire inputs

Complete the installation

See also

–

Install the transformer, page 24

–

Communication Information, page 68

–

B426/B426-M Conettix Ethernet Communication Modules, page 21

–

B450/B450-M Conettix Plug-in Communicator Interfaces, page 21

–

Codepads, page 14

–

RADION keyfobs, page 19

–

Keyswitches, page 23

–

WE800EV2 receiver, page 18

–

B308 Octo-output Module, page 20

Bosch Security Systems, Inc.

Installation Guide 2017.10 | 03 | F.01U.298.026