advertisement
Installation
2 Installation
2.1 Installation At The CNC
Proper communication between the PC and the Cutting Machine requires setting the same parameters at both ends.
2.1.1 Series 2000 CNC
The communication parameters at the Series 2000 are contained in machine constants 106 through 113, and may be set as shown below:
106 06 This sets serial port X28 to UDL
107 9600 Baud Rate, may be changed (max 9600)
108 8
109 2
110 0
111 0
112 0
113 0
Data Bits
Stop Bits
Parity must be zero, selects hardware handshaking must be zero must be zero
2.1.2 Vision 500, 1000, 2000, 3000 CNC
The communication parameters for a Vision CNC are set up in the DEVICE CONSTANTS 17 through 24, and may be set as shown below:
17
18
19
20
21
22
23
24
4
8
1
0
9600 Baud Rate, may be changed (max 9600)
0 Parity
10
0
This sets serial port X28 to UDL
Data Bits
Stop Bits must be zero, selects hardware handshaking time out in seconds must be zero
2.1.3 Vision PC, Vision NT CNC
The communication parameters for a Vision CNC are set up in the Operator’s Control Constants
(OCC) 1 through 8 and 33, and may be set as shown below:
1
2
3
4
5
6
7
8
33
04
9600 Baud Rate. Legal values are 4800, 9600, 19200, 38400, 57600, 115200
0
8
1
0
10
0
4
This sets COM1 serial port to UDL
Parity
Data Bits
Stop Bits must be zero, selects hardware handshaking time out in seconds must be zero
Must be 4 if used with 32 bit WinUDL, 1 if used with 16 bit WinUDL
Page 2
advertisement