Connecting to Additional Machines. ESAB WinUDL

WinUDL

3.5 Connecting to Additional Machines

To connect more than one ESAB CNC to the same host PC:

1. Follow the steps in the Software Installation section of this manual, but give each installation of WinUDL a different name. It is recommended that each installation be named according to the type of machine, or the customer’s internal machine number, for the machine to which that WinUDL installation is connected.

2. Run the new WinUDL by selecting its shortcut from the Windows START menu.

4. Complete the appropriate steps in the Preliminary Setup section of this manual for the new installation of WinUDL.

You can use as many copies of WinUDL as unoccupied COM ports are available on your PC.

Page 15

F 14 - 144 6/99 Printed in USA