advertisement
▼
Scroll to page 2
of
85
Oil Cooled Disc Brake
IDCS211S
(1), (2) Put LOCTITE NO.17430 Liquid Gasket on contact surface area of the axle flange cover assembly and cover before installation.
(3) Thickness of one new Plate ...2.50 ± .064 mm
(.100 ± .0025 in)
Thickness of one new friction disc: .................
........................ 4.59 ±.13 mm (.181 ± .005 in)
Minimum depth of grooves before the replacement of frictiondine is necessary .........
...........................................0.32 mm (.013 in)
Soak new discs in drive axle oil for one hour before installing.
Vehicle System 19 Specification
advertisement
Related manuals
advertisement
Table of contents
- 7 Hydraulic Control Valve
- 8 Hydraulic Pump
- 8 Lift Cylinders
- 9 Full Free Triple Lift and Full Free Lift Primary
- 9 Lift Secondary
- 10 Tilt Cylinder
- 11 Carriage
- 12 Lift Relay Group
- 12 Standard Lift
- 13 Full Free Lift
- 14 Full Free Triple
- 15 Quad Lift
- 16 Lift & Tilt Mounting Group
- 17 Steering Wheel
- 18 Steering Gear
- 19 Steer Axle and Wheel
- 20 Steer Tire Installation
- 20 (GC Models Only)
- 20 Steer Wheel Mounting
- 20 Oil Cooled Disc Brake
- 21 Parking Brake
- 22 Hydraulic Schematic
- 24 Control Valve
- 24 External Configuration
- 24 Hydraulic Circuit
- 25 Inlet Block - Key On
- 26 Lift Spool - Positioned to Lift
- 27 Lift Spool - Positioned to Lower
- 27 Tilt Spool - Positioned for Forward Tilt
- 28 Tilt Spool - Positioned for Backward Tilt
- 29 Shifting
- 29 Pressure and Flow Control Section
- 30 Flow Control Adjustment - Tilt and Auxiliary
- 31 STEERING SYSTEM
- 31 Hydraulic Schematic
- 32 Steering Cylinder
- 33 Steering Gear
- 35 Brake Power Master Cylinder
- 37 Oil Cooled Disc Brake
- 37 Parking Brake
- 38 Delayed Engine Shutdown System
- 38 Operation
- 40 System
- 40 Diagnostic Fault Codes
- 44 OSS (Operator Sensing System)
- 45 Operation
- 45 Symbols of OSS
- 46 Operator Sensing System Schematic
- 49 Troubleshooting
- 49 Visual Checks
- 49 Performance Test
- 51 Hydraulic System and Mast
- 52 Hydraulic Pump
- 53 Hydraulic Control Valve
- 54 Lift and Tilt Cylinders
- 55 Steering System
- 56 Power Master Cylinder
- 57 Brake System
- 58 Hydraulic System
- 58 Relief Valve Pressure Check
- 60 Standard Lift Cylinder Air Removal
- 61 Mast and Carriage
- 61 Mast Adjustment - STD, FFL & FFT
- 66 Mast Adjustment - Quad
- 71 Carriage Adjustment
- 73 Quad Mast
- 74 Chain Adjustment
- 75 Chain Wear Test
- 76 Carriage and Mast Height Adjustment
- 76 Forks Parallel Check
- 77 Tilt Cylinder Alignment
- 79 Drift Test
- 80 Steering System
- 80 Steer Wheel Bearing Adjustment
- 80 Steering Axle Stop Adjustment
- 81 Steering System Pressure Check
- 83 Brake System
- 83 Brake System Air Removal
- 83 Parking Brake Test
- 84 Parking Brake Adjustment