Setup Misc. (MFC-5490CN only). Brother IEEE 802.11b, MFC-490CW, Version B, MFC-5490CN, G, MFC-6890CDW, MFC-790CW, MFC-990CW, DCP-585CW, MFC-6490CW

Control panel setup

Setup Misc. (MFC-5490CN only)

6

Ethernet

Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT full or half duplex mode by auto negotiation.

You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and

10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been reset (default is Auto).

6

Note

If you incorrectly set this value, you may not be able to communicate with your print server.

a Press Menu, 5, 2, 1.

b Press a or b to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.

Press OK.

c Press Stop/Exit.

6

Setup Wizard (wireless network only)

The Setup Wizard guides you through the wireless network configuration. For more information, see Using

the Setup Wizard from the control panel on page 27.

6

SES/WPS/AOSS (wireless network only)

1

If your wireless access point supports either SecureEasySetup™, Wi-Fi Protected Setup™ (PBC

1

AOSS™, you can configure the machine easily without a computer. Your Brother machine has the

) or

SES/WPS/AOSS menu on the control panel. This feature automatically detects which mode your access point uses, SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™. By pushing a button on the wireless

LAN router / access point and the machine, you can setup the wireless network and security settings. See the user’s guide for your wireless LAN router / access point for instructions on how to access one-push mode.

(See Using the SES/WPS/AOSS control panel menu to configure your machine for a wireless network on page 31.)

Push Button Configuration

6

WPS w/PIN code (wireless network only)

If your wireless access point supports Wi-Fi Protected Setup™ (PIN Method), you can configure the machine easily without a computer. The PIN (Personal Identification Number) Method is one of the connection methods developed by the Wi-Fi Alliance. By inputting a PIN which is created by an Enrollee (your machine) to the Registrar (a device that manages the wireless LAN), you can setup the wireless network and security settings. See the user’s guide for your wireless LAN router / access point for instructions on how to access

the Wi-Fi Protected Setup™ mode. (See Using the PIN Method of Wi-Fi Protected Setup™ on page 35.)

6

89