advertisement
1 Foreword
1 Foreword
In the interest of your own safety and to prevent accidents, you should carefully read through the safety instructions, familiarize yourself with them, and observe them at all times.
The safety of the operator was one of the most important aspects taken into consideration when this machine was designed. Nevertheless, improper use or incorrect maintenance can pose a risk. Please operate and maintain your
Wacker machine in accordance with the instructions in the operator's manual.
Your reward will be troublefree operation and a high degree of availability.
Defective components should be replaced immediately!
If you have any questions regarding operation or maintenance, please contact your Wacker representative.
All rights reserved, especially reproduction and distribution rights.
Copyright 2005 Wacker Construction Equipment AG
No part of this manual may be reproduced, processed, copied or distributed by any means without the expressed written permission of Wacker.
Any type of reproduction, distribution or storage on data media of any type and form not authorized by Wacker represents an infringement of copyright and will be prosecuted.
We expressly reserve the right to make technical modifications - even without special notice - which aim at further improving our machines or their safety standards.
3
1 Foreword
4
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Foreword
- 7 Safety instructions
- 7 Proper use
- 7 General notes
- 8 Fuel, Lubricants, and Coolants / Filling the tank
- 9 Starting up
- 10 Cutting discs
- 13 Kickback and pulling motion
- 14 Maintenance
- 15 Starting up
- 16 Attaching the cutting disc
- 17 Fuel, lubricants, and coolants
- 19 Storing fuel
- 20 Filling the tank
- 21 Starting the engine
- 22 Cold start
- 23 Warm start
- 23 Turning off the engine
- 24 Setting the carburetor
- 25 Technical data
- 27 Special tools
- 29 Disassembly
- 29 Cover/Handle
- 31 Clutch
- 35 Recoil starter
- 39 Filter cover/Filter
- 41 Ignition system module/intake manifold
- 49 Cylinder/Crankshaft
- 53 Vibration dampers
- 55 Protective hood/V-belt pulley
- 59 Disassembly/Inspection
- 59 Carburetor/Inspection
- 63 Assembly
- 63 Protective hood/V-belt pulley
- 67 Vibration dampers
- 69 Cylinder/Crankshaft
- 75 Ignition system module/intake manifold
- 79 Filter cover/Filter
- 81 Recoil starter
- 85 Clutch
- 89 Cover/Handle
- 91 Malfunction
- 93 Maintenance
- 93 Maintenance schedule
- 95 Cleaning the protective hood
- 96 Replacing the V-belt
- 97 Tightening the V-belt
- 98 Carburetor setting
- 100 Cleaning/Changing the air filter
- 103 Replacing the spark plug
- 105 Replacing the suction head
- 105 Replacing the starter rope
- 106 10.10 Miscellaneous
- 109 Torque values