advertisement
10 Maintenance
10.4
Tightening the V-belt
Note: To obtain the maximum cutting performance at the lowest fuel consumption, it is absolutely necessary to tighten the V-belt precisely. An incorrectly tightened V-belt leads to premature wearing of the V-belt and V-belt pulley or to damage on the clutch bearing. Do not retighten the V-belt until after one hour of operation!
Note: To tighten the V-belt and to check the tension, you must loosen both mounting nuts (11).
• To increase the tension, turn the tension screw (12) in the clockwise direction with the combination wrench included in delivery.
• The V-belt is correctly adjusted if the marking (14) is centered between the nuts (13).
Note: After you tighten/test the V-belt, make sure to tighten the mounting nuts (11) to 30 + 2 Nm (22 + 1.5 ft.lbs.).
95
Tightening the V-belt
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Foreword
- 7 Safety instructions
- 7 Proper use
- 7 General notes
- 8 Fuel, Lubricants, and Coolants / Filling the tank
- 9 Starting up
- 10 Cutting discs
- 13 Kickback and pulling motion
- 14 Maintenance
- 15 Starting up
- 16 Attaching the cutting disc
- 17 Fuel, lubricants, and coolants
- 19 Storing fuel
- 20 Filling the tank
- 21 Starting the engine
- 22 Cold start
- 23 Warm start
- 23 Turning off the engine
- 24 Setting the carburetor
- 25 Technical data
- 27 Special tools
- 29 Disassembly
- 29 Cover/Handle
- 31 Clutch
- 35 Recoil starter
- 39 Filter cover/Filter
- 41 Ignition system module/intake manifold
- 49 Cylinder/Crankshaft
- 53 Vibration dampers
- 55 Protective hood/V-belt pulley
- 59 Disassembly/Inspection
- 59 Carburetor/Inspection
- 63 Assembly
- 63 Protective hood/V-belt pulley
- 67 Vibration dampers
- 69 Cylinder/Crankshaft
- 75 Ignition system module/intake manifold
- 79 Filter cover/Filter
- 81 Recoil starter
- 85 Clutch
- 89 Cover/Handle
- 91 Malfunction
- 93 Maintenance
- 93 Maintenance schedule
- 95 Cleaning the protective hood
- 96 Replacing the V-belt
- 97 Tightening the V-belt
- 98 Carburetor setting
- 100 Cleaning/Changing the air filter
- 103 Replacing the spark plug
- 105 Replacing the suction head
- 105 Replacing the starter rope
- 106 10.10 Miscellaneous
- 109 Torque values