advertisement
3 Starting up
3.4
Filling the tank
Fuel mixture
Note: Strictly observe the safety instructions in the operator's manual!
• Fuels must be handled carefully and prudently.
• Only when the engine is turned off and has cooled down!
• Clean the filling area so that no dirt can get into the tank.
• Set the machine on its side on a flat base.
• Screw off the tank cap and pour in the fuel mixture. Pour it in carefully to avoid spilling the fuel mixture.
• Tightly screw the tank cap back on.
• Clean the tank cap and surrounding area after you are finished! Never start or operate the unit at the location where you filled the tank! Should you spill fuel on your clothing, change your clothes immediately.
18
Filling the tank
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Foreword
- 7 Safety instructions
- 7 Proper use
- 7 General notes
- 8 Fuel, Lubricants, and Coolants / Filling the tank
- 9 Starting up
- 10 Cutting discs
- 13 Kickback and pulling motion
- 14 Maintenance
- 15 Starting up
- 16 Attaching the cutting disc
- 17 Fuel, lubricants, and coolants
- 19 Storing fuel
- 20 Filling the tank
- 21 Starting the engine
- 22 Cold start
- 23 Warm start
- 23 Turning off the engine
- 24 Setting the carburetor
- 25 Technical data
- 27 Special tools
- 29 Disassembly
- 29 Cover/Handle
- 31 Clutch
- 35 Recoil starter
- 39 Filter cover/Filter
- 41 Ignition system module/intake manifold
- 49 Cylinder/Crankshaft
- 53 Vibration dampers
- 55 Protective hood/V-belt pulley
- 59 Disassembly/Inspection
- 59 Carburetor/Inspection
- 63 Assembly
- 63 Protective hood/V-belt pulley
- 67 Vibration dampers
- 69 Cylinder/Crankshaft
- 75 Ignition system module/intake manifold
- 79 Filter cover/Filter
- 81 Recoil starter
- 85 Clutch
- 89 Cover/Handle
- 91 Malfunction
- 93 Maintenance
- 93 Maintenance schedule
- 95 Cleaning the protective hood
- 96 Replacing the V-belt
- 97 Tightening the V-belt
- 98 Carburetor setting
- 100 Cleaning/Changing the air filter
- 103 Replacing the spark plug
- 105 Replacing the suction head
- 105 Replacing the starter rope
- 106 10.10 Miscellaneous
- 109 Torque values