Getting started. Siemens SP65
تبلیغات
تبلیغات
left page (9) of SP65 FUG en, A31008-H7450-A1-1-7619 (03.03.2005, 11:41)
Getting started
Getting started
The phone is packaged in dismantled form and must be re-assembled prior to using for the first time.
Your phone's display is supplied with a protective film .
Remove this film slowly before assembling the phone.
In rare cases, static discharge may cause discolouration at the edges of the display. However, this will disappear within approx. 10 minutes.
Inserting the SIM card/ battery
The service provider supplies you with a SIM card on which all the important data for your line is stored. If the SIM card has been delivered in credit-card size, snap the smaller segment out and remove any rough edges.
• Press the grooved area
2 .
1 , then push the battery cover towards the front in the direction indicated by the arrow
1
2
• Place the SIM card flat in front of the slot with the contact surface facing downwards. Then push the
SIM card in using gentle pressure
3 (ensure that the chamfered corner is in the correct position).
3
9
left page (10) of SP65 FUG en, A31008-H7450-A1-1-7619 (03.03.2005, 11:41)
10 Getting started
• Insert the battery sideways into the phone wards tion.
5
4 , then press it down-
until it clicks into posi-
5
4
Inserting an
RS MultiMediaCard™
The RS MultiMediaCard is not included in the phone's delivery package. Please observe the manufacturer's operating instructions that come with the RS MultiMediaCard.
• To insert the RS MultiMediaCard, fold the cover out and down 1 .
• To remove the battery, pull it out with the retaining tab on the side.
• Place the cover in position and push it towards the front it latches into place.
6 until
1
• Open the cover completely, then insert the RS MultiMediaCard with the contact surface facing downwards 2 . Gently push the card right in until it clicks into place.
6
2
Additional information
Please switch off your phone before removing the battery!
The phone supports 1.8 V and 3 V SIM cards. Please contact your service provider if you have an older card.
left page (11) of SP65 FUG en, A31008-H7450-A1-1-7619 (03.03.2005, 11:41)
• If necessary, use the battery cover 3 .
Getting started 11
Charging the battery
Charging procedure
The battery is not fully charged when delivered. Plug the charger cable into the bottom of the phone, plug the power supply unit into a mains power socket and charge for at least two hours.
3
• Finally, close the cover again.
• Before removing the RS MultiMedia-
Card, carry out the Eject card function in the My stuff options menu.
This prevents any possible data loss.
• To remove the
RS MultiMedia-Card, open the cover and press the card briefly
(if necessary, use the battery cover). The card will pop out a little and you can remove it.
Finally, close the cover again.
Display during charging.
Y
Charging time
An empty battery is fully charged after about 2 hours. Charging is only possible within a temperature range of 5 °C to 45 °C. If the temperature rises/falls 5 °C above/below this, the charge symbol flashes a warning.
The mains voltage specified on the power supply unit must not be exceeded.
left page (12) of SP65 FUG en, A31008-H7450-A1-1-7619 (03.03.2005, 11:41)
12 Getting started
Operating times
The operating time depends upon the respective conditions of use.
Extreme temperatures considerably reduce the phone’s standby time.
Avoid placing the phone in the sun or on a heater.
Talktime: 100 to 300 minutes
Standby time: 60 to 250 hours
Charge icon not visible
If the battery has been discharged fully, the charge icon is not immediately visible when the power supply is plugged in. It will appear after up to two hours. In this case, the battery is fully charged after 3 to 4 hours.
Only use the plug-in power supply unit included in delivery!
Display while in service
Charge level display during operation (empty – full):
V W X
A beep sounds when the battery is nearly empty. The charge level of the battery is only displayed correctly after an uninterrupted charging/discharging cycle. Therefore do not remove the battery unnecessarily , and where possible, do not end the charging process prematurely.
Additional information
The power supply unit heats up when used for long periods. This is normal and not dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.
دانلود
تبلیغات
ویژگیهای کلیدی
Black
132 x 176 pixels
MMC
Bluetooth
Multimedia Messaging Service (MMS)
Lithium-Ion (Li-Ion) 750 mAh