advertisement
EAS00038
COVER AND PANEL
SIDE COVERS AND TAIL/BRAKE LIGHT
COVER AND PANEL
CHK
ADJ
< &
Order
5
6
7
8
1
2
3
4
Job/Part
Removing the side covers and tail/ brake light
Front cover
Side cover(left)
Side cover(right)
Tail/brake and rear turn signal light(left and right)
Battery cover
Battery negative lead
Battery positive lead
Battery
Q’ty
Remarks
Remove the parts in the order listed.
1
1
1
1
1
1
1
1 c
C
8First, disconnect the negative battery lead, and then the positive battery lead.
8After installing the battery be sure to turn the main switch from “ON” to “OFF” three times in 3 seconds intervals to initialize the idle speed
3-5
COVER AND PANEL
CHK
ADJ
< &
Order Job/Part
Q’ty
Remarks control system.
For installation, reverse the removal procedure.
3-6
SINGLE SEAT AND TRUNK
COVER AND PANEL
CHK
ADJ
< &
\y10Nm(1.0m • kg, 7.2 ft • lb)
\ l 12Nm(1.2m« kg, 8.7 ft* lb)
[s& 7Nm(0.7m• kg, 5.1 ft• lb)
" 10
/ \
/ \
/
'/* *£® /
/
/
/ 8
Order Job/Part
Removing the single seat and trunk
Side cover(left and right)
1
2
3
4
5
6
7
Single seat
Single seat upper cover
Bottom plate
Frame(single seat)
ECU
Starter relay
Main fuse
8 Single seat lock assembly
9 Helmet holder
10 Trunk
Remarks
Q’ty
Remove the parts in the order listed.
Refer to “SIDE COVERS AND TAIL/
BRAKE LIGHT”.
1
1
2
1
1 Disconnect.
1 Disconnect.
1 Disconnect.
1
1
1
For installation, reverse the removal procedure.
3-7
LEG SHIELD1,2
COVER AND PANEL
CHK
ADJ
< &
Order Job/Part
Q’ty
Remarks
Remove the parts in the order listed.
Caution, do not damage the claw while removing.
For installation, reverse the removal procedure.
3-8
FOOTREST BOARD AND INNER FENDER
COVER AND PANEL
CHK
ADJ
< &
Order Job/Part
Q’ty
Remarks
Remove the parts in the order listed.
Refer to “SINGLE SEAT AND TRUNK “.
When installing the fuel tank cap, align it cap end and the mark on the car body.
Disconnect.
For installation, reverse the removal procedure.
3-9
advertisement