Oil Pump. Yamaha XF50W

Add to My manuals
338 Pages

advertisement

Oil Pump. Yamaha XF50W | Manualzz

OIL PUMP

ENG %m

EAS00360

OIL PUMP

4Nm (0.4 m « kg, 2.9 f H b)

Order

1

2

3

4

5

Job/Part

Removing the oil pump

Radiator

AC magneto

Starter clutch

Drive gear

Circlip/Plate washer

Oil pump driven gear

Dowel pin

Oil pump

3

Q’ty

Remarks

Remove the parts in the order listed.

Refer to”RADIATOR”in chapter 6.

1

1/1

1

2

1

For installation, reverse the removal procedure.

5-61

11710404

OIL PUMP

EAS00364

CHECKING THE OIL PUMP

1. Check:

• oil pump drive gear

• oil pump driven gear ©

• oil pump housing

• oil pump housing cover

Cracks/damage/wear -» Replace the defective part(s).

2. Measure:

• inner-rotor-to-outer-rotor-tip clearance A

• outer-rotor-to-oil-pump-housing clearance \B\

• oil-pump-housing-to-inner-rotor-andouter-rotor clearance \c\

Out of specification -» Replace the oil pump.

© Inner rotor

(2) Outer rotor

(3) Oil pump housing

Inner-rotor-to-outer-rotor-tip clearance

0.15 mm (0.006 in) or less

<Limit>: 0.23 mm (0.009 in)

Outer-rotor-to-oil-pump-housing clearance

0.13 ~ 0.18 mm (0.005 ~ 0.007 in)

<Limit>: 0.25mm (0.010 in)

Oil-pump-housing-to-inner-rotorand-outer-rotor clearance

0.07 ~ 0.12 mm (0.003 ~ 0.005 in)

<Limit>: 0.19 mm (0.008 in)

5-62

3. Check:

• oil pump operation

Rough movement -» Repeat steps (1) and

(2) or replace the defective part(s).

5-63

OIL PUMP

ENG %m

EAS00375

ASSEMBLING THE OIL PUMP

1. Lubricate:

8inner rotor

8outer rotor

8oil pump shaft

(with the recommended lubricant)

Recommended lubricant

Engine oil

2. Install:

8 oil pump shaft (T)

(to the oil pump housing ® )

8 pin (3)

8 inner rotor ®

8 outer rotor ©

8 oil pump housing cover ®

8 oil pump housing screw

X I 4 Nm (0.4 m * kg, 2.9 ft * lb)

NOTE:

When installing the inner rotor, align the pin (3) in the oil pump shaft with the groove a in the inner rotor (4) .

3. Check:

8 oil pump operation

Refer to “CHECKING THE OIL PUMP”.

EAS00376

INSTALLING THE OIL PUMP

1. Install:

8oil pump drive gear 1

8gasket New

8oil p u m p 2

8oil pump bolt

\ | 4 Nm (0.4 m * kg, 2.9 ft * lb)

C

After tightening the bolts, make sure the oil pump turns smoothly.

advertisement

Related manuals

Download PDF

advertisement

Table of contents