STEREO-DDL-L. Art MULTIVERB III

STEREO-DDL-L

[STREO-DDL-L], [DDL]

Stereo Digital Delay - Long

Parameters:

:DLY-L=* [250ms] 0 to 1300ms, increments:5ms;0-350, 10ms;350-700 20ms;700-1000,

50ms;1000-1300

:L-FINE* = [0ms] 0 to 50 ms in 1 ms increments

:DLY-R* = [125ms] 0 to 1300ms, increments:5ms;0-350, 10ms;350-700 20ms;700-1000,

50ms;1000-1300

:R-FINE* = [0ms] 0 to 50ms in 1ms increments

:REGEN= [45%] 0 to 100 percent in % increments

:HFDAMP= [0%] 0 to 100 percent in % increments

:LEVEL= [100%] 0 to 100 percent in % increments

*Total possible delay is 1350ms

You can split image or create alternating regenerative patterns between the left and right outputs using Stereo Digital Delay. The ability to set separate delay times for each channel enables you to do this. When used in conjunction with the

Flanger, Chorus or Panner, spatial effects are the result. Regeneration is derived from the left channel.

When longer delay times are needed, use the STREO-DDL-L algorithm. Set both Left and Right Delay times at 1300 ms for maximum delay output with no separation. You may also operate this effect in mono.

SAMPLER-S

[SAMPLER-S], [SMP]

Sampler-Short

Parameters:

STAT= [REC-RDY] REC-RDY, PLAY, IDLE

RECORD= [AUTO] AUTO, MANUL, MIDI

PLAY= [SINGLE] SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO

LENGTH= [1.3s] 0.02 to 1.30 seconds in 20ms increments

START= [5ms] 0 to 100ms in 1ms increments

LEVEL= [100%] 0 to 100 percent in % increments

SAMPLER-L

[SAMPLER-L], SMP

Sampler-Long

Parameters:

STAT= [REC-RDY] REC-RDY, PLAY, IDLE

RECORD= [AUTO] AUTO, MANUL, MIDI

PLAY= [SINGLE] SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO

LENGTH= [1.58s] 0.02 to 1.58 seconds in 20ms increments

START= [5ms] 0 to 100ms

LEVEL= [100%] 0 to 100 percent in % increments

30