- No category
advertisement
4
General Safety Summary
Please read the following safety precautions to ensure proper use of your Inspira ventilator. To avoid potential hazards and product damage, use this product only as instructed in this manual.
TO PREVENT HAZARD OR INJURY:
Use Proper Line Cord
Use only the specified line cord for this product and make sure line cord is certified for country of use.
Ground the Product
This product is grounded through the grounding conductor of the power cord. To avoid electric shock, the grounding conductor must be connected to earth ground.
Before making any connections to the input or output terminals of the product, ensure that the product is properly grounded.
Make Proper Connections
Make sure all connections are made properly and securely. Any signal wire connections to the Inspira unit must be no longer than 3 meters.
Observe all Terminal Ratings
Review the operating manual to learn the ratings on all Inspira connections.
Do Not Operate Without Cover
Make sure that the top cover is securely in place before connecting to power source to avoid injury to body and damage to the product.
Use Proper Fuse
Use only specified fuses with product.
Avoid Exposed Circuitry
Do not touch any electronic circuitry inside of the product.
Do Not Operate with Suspected Failures
If damage is suspected on or to the product do not operate the product. Contact qualified service personnel to perform inspection.
Place Product in Proper Environment
Review the operating manual for guidelines for proper operating environments.
Observe all Warning Labels on Product
Read all labels on product to ensure proper usage.
Protective Ground
Terminal
CAUTION
Refer to Manual
Publication 5404-001-REV-C
advertisement
Related manuals
advertisement
Table of contents
- 5 Warranty and Repair Information
- 6 General Safety Summary
- 7 Theory of Operation
- 7 Features
- 9 Initial Setup and Location Requirements
- 9 Typical Operation
- 10 Airway Tubing Connections: Front Panel
- 11 Electrical Connections: Front Panel
- 12 Electrical Connections: Rear Panel
- 13 Air Cylinder Installation
- 14 Fuse Replacement
- 15 Turning Ventilator On
- 16 Main Operating Screens
- 17 Key Functions
- 18 Respiratory Profiles
- 20 Entering Animal Weight
- 21 Starting and Stopping Ventilation
- 21 Displaying Ventilation Parameters
- 22 Warnings and Faults
- 24 Entering Respiration Rate
- 24 Entering Tidal Volume
- 25 Entering Sigh Breath
- 25 Disabling Sigh Breath
- 27 Entering I:E Ratio
- 28 Inspiration Pressure
- 29 Assist Pressure
- 30 Inspiration Pressure
- 31 Assist Pressure
- 31 PEEP Pressure
- 32 Sigh Pressure
- 33 Volume Mode
- 33 Pressure Mode
- 33 Assist Mode
- 34 User Override
- 34 Using Digital and Analog I/O Ports
- 35 Remote Control/Monitoring (Serial Communications)
- 38 Changing Air Cylinders
- 39 Hardware Setup
- 41 Diagnostics
- 46 Power Failure
- 46 General Maintenance and Cleaning
- 47 General Specifications
- 48 I/O Specifications
- 49 Serial Commands, Queries and Responses
- 51 Glossary of Terms
- 52 Sample Waveforms
- 53 Frequently Asked Questions
- 55 Recommended Cylinder Size
- 56 Recommended Port Size
- 57 Using Inspira with Pressurized and Anesthetic Gasses
- 58 Generating PEEP with Inspira ASVv