- No category
advertisement
10
Installation
Electrical Connections:
Rear Panel
Inspira provides power entry, RS232 communications, and User I/O (Optional) connections at the rear of the machine. Their functions are as follows:
User I/O
Not used in this model.
RS232 In
For use with a host computer to establish a communication connection between the computer and the Inspira.
1. No connection
2. Transmit Data (TXD)
3. Receive Data (RXD)
4. Data Terminal Ready Input (DTR)1
5. Signal Ground (GND)
6. No Connection
Figure 5. Rear Panel
7. Request to Send Input (RTS)2
8. No Connection
Figure 6. RS232 Connector
9. No Connection
1 Used for Vpp Enable in optional flash programming configuration; disabled in hardware.
2 Used as Serial Reset in optional flash programming configuration; disabled in hardware.
RS232 Out
Used to establish a daisy chain serial connection with other devices. Future models will support a serial printer connection through this port.
1. No connection
2. Receive Data (RXD)
3. Transmit Data (TXD)
4. No Connection
5. Signal Ground (GND)
6. No Connection
7. No Connection
8. No Connection
9. No Connection
Power Connection
Power in.
Note: Electrical specifications for these signals are given in Appendix A.
Publication 5404-001-REV-C
advertisement
Related manuals
advertisement
Table of contents
- 5 Warranty and Repair Information
- 6 General Safety Summary
- 7 Theory of Operation
- 7 Features
- 9 Initial Setup and Location Requirements
- 9 Typical Operation
- 10 Airway Tubing Connections: Front Panel
- 11 Electrical Connections: Front Panel
- 12 Electrical Connections: Rear Panel
- 13 Air Cylinder Installation
- 14 Fuse Replacement
- 15 Turning Ventilator On
- 16 Main Operating Screens
- 17 Key Functions
- 18 Respiratory Profiles
- 20 Entering Animal Weight
- 21 Starting and Stopping Ventilation
- 21 Displaying Ventilation Parameters
- 22 Warnings and Faults
- 24 Entering Respiration Rate
- 24 Entering Tidal Volume
- 25 Entering Sigh Breath
- 25 Disabling Sigh Breath
- 27 Entering I:E Ratio
- 28 Inspiration Pressure
- 29 Assist Pressure
- 30 Inspiration Pressure
- 31 Assist Pressure
- 31 PEEP Pressure
- 32 Sigh Pressure
- 33 Volume Mode
- 33 Pressure Mode
- 33 Assist Mode
- 34 User Override
- 34 Using Digital and Analog I/O Ports
- 35 Remote Control/Monitoring (Serial Communications)
- 38 Changing Air Cylinders
- 39 Hardware Setup
- 41 Diagnostics
- 46 Power Failure
- 46 General Maintenance and Cleaning
- 47 General Specifications
- 48 I/O Specifications
- 49 Serial Commands, Queries and Responses
- 51 Glossary of Terms
- 52 Sample Waveforms
- 53 Frequently Asked Questions
- 55 Recommended Cylinder Size
- 56 Recommended Port Size
- 57 Using Inspira with Pressurized and Anesthetic Gasses
- 58 Generating PEEP with Inspira ASVv