- Complete the Installation. Whirlpool WRF767SDHV, WRF767SDHZ

INSTALLATION INSTRUCTIONS

3.

Turn on water supply to refrigerator and check for leaks.

Correct any leaks.

Style 2

1.

Unplug refrigerator or disconnect power.

2.

Remove and discard the short, black plastic part from the end of the water line inlet.

3.

Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE:

To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

Complete the Installation

WARNING

A B C

A. Household water line

B. Nut (purchased)

D

C. Ferrule (purchased)

D. Refrigerator water tubing

4.

Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

5.

Turn ON shutoff valve.

6.

Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

7.

On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄ " (6.35 mm) water line at either tube connection. Obtain a water strainer from your appliance dealer.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.

Plug into a grounded 3 prong outlet.

2.

Flush the water system. See “Water and Ice Dispensers.”

NOTE:

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice storage bin.

Handle Installation and Removal

Parts Included:

Door handles (2), Drawer handle(s) (1 or 2 depending on model), ¹⁄₈ " hex key, spare setscrew(s)

NOTE:

With the handles laying on a flat surface, the handles intended for the drawers are more curved. They will not mount flush against the doors.

Install Handles

NOTE:

Handle mounting setscrews are preinstalled inside the handle.

1.

Remove the handles from the packaging inside the refrigerator, and place them on a soft surface.

2.

Open a refrigerator compartment door. On the closed door, place a handle onto the shoulder screws so that the setscrews are facing the adjacent door.

A

B

A. Shoulder screws

B. Setscrews inside the handle

3.

Firmly push the handle toward the door until the handle base is flush against the door.

13