- Replace the Water Filter. Whirlpool WRF767SDHV, WRF767SDHZ

Add to My manuals
84 Pages

advertisement

- Replace the Water Filter. Whirlpool WRF767SDHV, WRF767SDHZ | Manualzz

FILTERS AND ACCESSORIES

RESET the water filter status tracking feature. After you replace the disposable filter with a new filter, closing the filter compartment door will automatically reset the filter status tracking feature. See “Using the Control(s).”

NOTE:

“REPLACE FILTER” will remain illuminated if a filter is not installed or is installed incorrectly.

Replace the Water Filter

To purchase a replacement water filter, see “Accessories” in the

User Guide, Use and Care Guide or User Instructions.

Replace the disposable water filter when indicated on the water filter status display or at least every 6 months. If water flow to your dispenser or ice maker decreases noticeably, change the water filter sooner.

Install Air Filter

(on some models)

An air filter is 15 times more powerful than baking soda at reducing common food odors inside the refrigerator.

On some models, your refrigerator's accessory packet includes an air filter, which must be installed prior to use.

1.

Locate the water filter compartment in the right-hand side of the refrigerator ceiling. Push up to release and lower the compartment door.

2.

Turn the water filter counterclockwise (to the left), and pull it straight out of the compartment.

NOTE:

There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills.

3.

Install the replacement water filter by following steps 2 through 7 in the “Install the Water Filter” section.

Installing the Filter Status Indicator

The filter comes with a status indicator, which should be activated and installed at the same time the air filter is installed.

Installing the Air Filter

Install the air filter behind the vented door, located on the rear wall near the top of the refrigerator compartment.

1.

Remove the air filter from its packaging.

2.

Lift open the vented door.

3.

Snap the filter into place.

1.

Place the indicator face-down on a firm, flat surface.

2.

Apply pressure to the bubble on the back of the indicator until the bubble pops to activate the indicator.

3.

Lift open the vented air filter door. On some models, there are notches behind the door.

Models with notches:

With the indicator screen facing outward, slide the indicator down into the notches.

NOTE:

The indicator will not easily slide into the notches if the bubble has not been popped.

Close the air filter door, and check that the indicator is visible through the window in the door.

A

A

B

A. Air filter

C

A. Status indicator window

B. Air filter status indicator

C. Notches

17

advertisement

Key Features

  • French Door design for easy access to food
  • Bottom-mount freezer for more refrigerator space
  • Adjustable shelves and door bins for customized storage
  • Temperature-controlled drawer for optimal preservation of food
  • Water dispenser with built-in filtration system

Related manuals

Frequently Answers and Questions

How do I install the water filter?
Refer to the 'Filters and Accessories' section in the Use and Care Guide for detailed instructions on installing the water filter.
How do I adjust the temperature of the refrigerator?
The temperature of the refrigerator can be adjusted using the electronic controls located inside the refrigerator compartment.
How do I remove the refrigerator door?
Follow the steps outlined in the 'Installation Instructions' section of the Use and Care Guide to safely remove the refrigerator door.

advertisement

Table of contents