- Cooling On/Off. Whirlpool WRF767SDHV, WRF767SDHZ

REFRIGERATOR USE

When Temperature mode is activated, press TEMP to toggle between Fridge and Freezer. The display will show the temperature set point of the selected compartment, and temperature adjusting information will appear on the display screen.

Recommended Refrigerator Temperature

Recommended Freezer Temperature

When adjusting temperature set points, use the following chart as a guide:

CONDITION:

REFRIGERATOR too cold

REFRIGERATOR too warm

FREEZER too cold

FREEZER too warm /

Too little ice

TEMPERATURE

ADJUSTMENT:

REFRIGERATOR Setting

1° higher

REFRIGERATOR Setting

1° lower

FREEZER Setting 1° higher

FREEZER Setting 1° lower

Cooling On/Off

Your refrigerator and freezer will not cool when cooling is turned off.

■

To turn Off cooling, press and hold LOCK and FAST ICE at the same time for 3 seconds. “Cooling Off” will blink seven times and then remain lit as shown.

IMPORTANT:

■

■

To avoid unintentionally locking the dispenser or changing other settings, press both buttons at exactly the same time.

When cooling is off, the dispenser paddles and all controls except Lock and Fast Ice are disabled.

Adjust Temperature Set Points

Refrigerator set point range: 33°F to 45°F (0°C to 7°C).

Freezer set point range: -5°F to 5°F (-21°C to -15°C).

1.

After Temperature mode is activated, press TEMP again to

Select Zone (Fridge or Freezer). The display will show the temperature set point of the selected compartment, as shown.

2.

Press LOCK to raise the set point, or press OPTIONS to lower the set point.

3.

When you have finished viewing (and adjusting if desired) the

Fridge zone set point, press TEMP, under Select Zone, to change the display to show the Freezer zone set point. When the zone has been changed, “FREEZER” appears on the display screen.

4.

Press the LOCK button to raise the set point, or press the

OPTIONS button to lower the set point.

Save/Confirm Temperature Settings

■

When you have finished adjusting both the refrigerator and freezer set points, press FAST ICE to confirm and to save the settings.

NOTE:

To exit Temperature mode without saving changes, press the ICE/WATER button under Back at any time, or allow about

60 seconds of inactivity. The temperature mode will turn off automatically and return to the normal screen.

■

A. Press LOCK and FAST ICE at the same time.

When cooling is off, press and hold LOCK and FAST ICE for

3 seconds to turn On cooling.

Options

Press the OPTIONS button to open the Options menu and select between Filter Status or Vacation mode.

Press the ICE/WATER button, under “Back,” at any time to return to the Home screen.

21