TROUBLESHOOTING. Whirlpool WRF767SDHV, WRF767SDHZ

TROUBLESHOOTING

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in this manual and scan the code with your mobile device, or visit www.whirlpool.com/product_help

.

In Canada, visit www.whirlpool.ca

.

Contact us by mail with any questions or concerns at the address below:

In the U.S.A.:

Whirlpool Brand Home Appliances

Customer eXperience Center

553 Benson Road

Benton Harbor, MI 49022-2692

In Canada:

Whirlpool Brand Home Appliances

Customer eXperience Centre

200 – 6750 Century Ave.

Mississauga, Ontario L5N 0B7

Please include a daytime phone number in your correspondence.

Operation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

PROBLEM

The refrigerator will not operate

POSSIBLE CAUSES

Check electrical supply

Check controls

New installation

Refrigerator control is in Showroom mode (on some models)

SOLUTIONS

Plug the power cord into a grounded 3 prong outlet.

Do not use an extension cord.

Make sure there is power to the outlet. Plug in a lamp to see if the outlet is working.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE:

If problems continue, contact an electrician.

Make sure the controls are turned on. See “Using the Control(s).”

Allow 24 hours following installation for the refrigerator to cool completely.

NOTE:

Adjusting the temperature controls to the coldest setting will not cool either compartment more quickly.

If the refrigerator is in Showroom mode, cooling is turned off and

“Showroom” will be illuminated on the control panel. See “Using the

Control(s)” for more information.

31