Rear of System. Stratasys FORTUS 900MC

REAR OF SYSTEM

The computer and the UPS are accessible from the back of the system.

Power In

Disconnect Switch

Onboard Computer UPS

ONBOARD COMPUTER

The onboard computer is the central control unit for the Fortus 900mc. This computer also runs the touchscreen software that provides for the system's user interface.

UPS

The UPS unit is a battery standby system that supplies power (AC voltage) to the computer, oven lights, and head cooling fan in the event of a loss of AC power. It does not power the entire system. You can access the

UPS from the back of the system. In the event of an overcurrent condition, the UPS is protected by a combination on/off switch and circuit breaker located directly above the main breaker.

• It shuts itself off if power is not restored to the system.

• If power is lost to the system you may need to manually power the unit back up. However, this should not be necessary unless the UPS has been manually turned off. To regain power, hold the “On” button on the front of the UPS unit until a beep is heard and/or LED lights appear.

• The LED display shows status of the UPS.

Alarm Indicator

(Red)

Up

On/Off

Button

On battery

Indicator

(Yellow)

Escape

Enter

Down

Power On

Indicator

(Green)

9

POWER IN DISCONNECT SWITCH

The Power In Disconnect switch, located at the back of the system, acts as the main circuit breaker. Rotating this switch to OFF will remove AC power to the system. There is a Lockout Bar that can be used to lock the switch in the off position.

Warning: High voltage is present in the system when powered off and unplugged because of the Uninterruptible Power supply (UPS).

Lockout Bar

POWER CONNECTION

Warning: A licensed electrician must perform all wiring from service connect to the transformer, and from the transformer to the system - including all connectors, cables and proper strain relief.

This system requires a high voltage connection, which is made at the top right-hand corner at the back of the system. High voltage is applied to the system using a Delta connection. The main breaker must be off until a

Stratasys authorized Service Technician has verified the connection. This system is only provided with a Delta connection.

High Voltage

Power Cable

Connection

NETWORK AND AIR SUPPLY CONNECTIONS

Processed job files are transferred to the Fortus system through your facility’s Ethernet network. An RJ45 network connector is located on the top right-hand corner at the back of the system. The air supply connection is located next to the RJ45 connector.

Power Cable

Connection

Air Supply

Connector

RJ45

Connector

10