Select a Job to Build. Stratasys FORTUS 900MC

iii. Make sure the active model and support canister bays have filament loaded to the head (steady green

LED).

iv. Make sure the loaded filament match the material requirements of the CMB file. Change material type if necessary.

v. The touchscreen warns if there is a material mis-match.

vi. Make sure that the tip cleaning brush and tips are clean.

vii. Empty the purge bucket.

viii. If using Auto-Cool Down, or if the material type has changed, allow the oven to heat and stabilize for at least four hours.

2. Modify System Defaults:

A. Display units - choose inches or metric.

B. User Placement on Platen - allows you to choose the part build location.

SELECT A JOB TO BUILD

From the Building screen, select one of the following job build options:

Build

Previous Job

Selected Job

Next Job

Queue

Window

1. Next Job

• Selects the first job in the job queue for build.

2. Previous Job - builds the last job completed.

• The previous job built by the system will be selected for build.

• If a previous job does not exist, the screen will show No Previous Job .

3. Queue Window

• The job queue is displayed.

• Select a specific job in the queue.

4. If the User Placement option is set to on, the following screen will appear.

38