advertisement
UNLOADING MATERIAL FROM THE LIQUEFIER TIPS
Note: Unloading filament from the liquefiers is done in the Idle mode only, not while building or in a paused state.
Perform the following steps to unload material from the liquefier tips:
1. Make sure the system is in the Pause or Idle mode.
2. From the Main Menu, select Operator Tools and the following screen will appear.
Unload
3. Select the material to be unloaded and press the Unload icon.
• The head warms up to the unload temperature, and the canister LED rapidly flashes green.
• The head drive motors and canister drive motor turn in reverse. The material is pulled back from the head about 4-6 inches (10-15 cm).
Note: For some materials (i.e., SR-20), a tip purge is performed before the material is unloaded from the liquefier.
• The head temperature lowers to standby temperature and the canister LED turns to a slower flashing green (same flash rate as used to indicate canister Ready condition).
• The display will show At Head for the unloaded material.
4. Replace the canister.
30
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- Advanced FDM Technology for High Precision and Detail
- Wide Range of Engineering-Grade Materials for Diverse Applications
- Large Build Volume for Large-Scale Projects
- Heated Build Chamber for Dimensional Stability
- Intuitive Control Panel for Ease of Use
- Connectivity Options for Remote Monitoring and Control
- Integrated Camera for Remote Build Monitoring
Related manuals
Frequently Answers and Questions
What is the maximum build volume of the FORTUS 900MC?
What materials are compatible with the FORTUS 900MC?
Does the FORTUS 900MC have a heated build chamber?
advertisement