advertisement
Self Help
Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following information may help you with a dishwasher problem without your having to call a repair person.
Dishes do not dry
The rinse aid dispenser may be empty. Check the rinse aid dispenser and refill it if necessary.
Dishware drying can be accelerated and enhanced by opening the dishwasher door slightly and propping it open with the top rack.
Indicator light(s) do not come on
Check the fuse or circuit breaker at your fuse box/ breaker box and replace the fuse or reset the breaker if necessary.
Dishwasher does not start
Make certain the dishwasher door is shut and latched. Make certain to press the START button before closing the door.
Suds in dishwasher
You may have used the wrong type of dishwasher detergent. Use only automatic dishwasher detergents.
White spots or streaks left on dishes and glassware
Go to the Rinse Aid Adjustment section of this manual for instructions on increasing the amount of rinse aid.
Water not pumped from dishwasher
Make certain the drain hose isn’t kinked, clogged, or improperly installed. Make certain a portion of the drain hose is at least 20 inches above the dishwasher’s enclosure floor (see the Installation
Manual). Filters may be clogged. Make certain the filter system isn’t clogged (see the Care and
Maintenance section of this manual). The kitchen sink drain may be clogged; you may need a plumber rather than a serviceman for the dishwasher. If an air gap is installed at sink, it may be clogged.
Dishwasher runs a long time
May be due to cold incoming water. Before starting the dishwasher, open the hot water faucet at the sink nearest the dishwasher. Run the water until it runs hot, then turn off the water and start the dishwasher.
Rattling noises
Utensils may not be properly arranged.
Machine cycle does not advance to rinse
NOTE: The Installation instructions that came with your dishwasher will help you with the following instructions.
The water supply line may be shut off. Check the water supply valve and open it if it’s shut.
Detergent dispenser cover will not shut
You may not be correctly shutting the detergent dispenser cover, or a cycle was not finished and should be canceled. Go to the Adding Detergent and Rinse Aid section of this manual for instructions on shutting the detergent dispenser cover. Go to the Operating the Dishwasher section of this manual for instructions on canceling a cycle.
Unsatisfactory washing results
• Incorrect amount of detergent.
• Utensils incorrectly arranged or rack overloaded.
• Spray arm rotation blocked by utensils.
• Spray arm nozzles need cleaning.
• Filters not properly fitted into position.
• Unsuitable cycle selected.
19
advertisement